CISCO-GPRS-ACC-PT-MIB Table View

This table contains a list of access points configured
on this Gateway.

This table contains the list of aggregate routes
configured on this APN. Gateway uses a static host route 
to forward user data packets for each PDP or Bearer context 
received from Gi interface to Gn interface.  Using the 
aggregate route (address range), total number of static 
routes implemented in the Gateway for PDP or Bearer requests
can be greatly reduced.  If there is no aggregate route 
configured on this access-point, then default aggregate 
routes configured on Gateway will be used.

This table is an extension of cgprsAccPtTable.

Each column in this table represent IP address of
different generic servers, for example: DNS, NetBIOS, 
configured on the APN.

Charging characteristics is a parameter that allows the
operator to apply different charging methods on a per
PDP or Bearer basis.  Each charging profile is associated
with an index, set of charging parameters like subscriber
category, volume limit trigger, etc., details of the
same is outside the scope of the MIB and are defined
in CISCO-GPRS-CHARGING-MIB.
          
Charging characteristics can be received from MME or SGSN as
an Information Element in the create PDP/Bearer request or
defaults can be configured at the Gateway and/or APN level.
          
This table represents the charging profiles that can
be applied to different type of mobile subscribers on
an APN.  The Gateway level configurations are dealt in
CISCO-GPRS-CHARGING-MIB.

Call Admission Control(CAC) on the Gateway ensures that
required network resources are available for real-time
data traffic, such as voice, video, etc., and to support
establishment and modification of the QoS parameters by
signaling and negotiating during PDP or Bearer context
activation procedure and modification procedure. CAC
performs this by examining various QoS parameters like
traffic class, maximum bit rate and guaranteed bit rate
for both uplink and downlink received from the MME or
SGSN with the local configured parameters or policy
received from Policy Decision Function(PDF).
          
This table represents various parameters required to
support CAC.

Route probe feature enables the Gateway to send out a route
probe packet to a configured destination after a
successful PDP or Bearer activation procedure.  The source IP
address of the packet would be the IP address of the
PDP or Bearer context.
          
This table represents various parameters set in the
route probe packet.  At this point, UDP packets will be
sent, a new column will be added to represent the
protocol when the support is extended to other
protocols.

The Gateway supports IPv6 PDP or Bearer type and its user
traffic. It will provide the IPv6 prefix and interface
identifier to the MS; generate IPv6 PDP or Bearer address
in the appropriate charging records and AAA accounting record.
          
This table represents various parameters required to 
support IPv6 PDP or Bearer under APN.

This table contains the list of CSG Groups
configured on this APN.

This table contains a history of access point
configuration change notifications generated by 
the agent for changes in the access point 
configuration. 
          
The object cgprsAccPtCfgNotifHistMax specifies the 
maximum number of entries stored in this table. 
When the table is full, the oldest entries are 
discarded to make space for new entries.

This table contains the performance statistics of
each APN on this Gateway.

This table contains the DHCPv6 proxy server
performance statistics for each APN on this Gateway.

This table contains the throughput statistics of
each APN on this Gateway.