RC-IPV6-MIB Table View

Route Smlt Table

Route Smlt Peer Table

RSMLT Edge Support Peer Info table. This 
table consists of the RSMLT Peers for which 
the switch will act as a PeerForwarder.

This table contains list of IPv6 interfaces and
per-interface IPv6-specific information.

This table contains addressing information relevant
to the entity's interfaces.
          
This table does not contain multicast address 
information. Tables for such information should be 
contained in multicast specific MIBs such as RFC3019.
          
While this table is writable the user will note that several
objects, such as rcIpv6AddressOrigin, are not. The 
intention in allowing a user to write to this table is to 
allow them to add or remove any entry that isn't permanent.
The user should be  allowed to modify objects and entries 
when that would not cause inconsistencies within the table.
Allowing write access to objects such as rcIpv6AddressOrigin
could allow a user to insert an entry and then label it 
incorrectly.

This table allows the user to 
determine the source of an IP address or set of 
IP addresses and allows other tables to
share the information via pointer rather than by copying.
          
For example when the node configures both a unicast and
anycast address for a prefix the ipAddressPrefix objects for
those addresses will point to a single row in this table.
          
          
This table primarily provides support for IPv6 prefixes and
several of the objects are less meaningful for IPv4.  The
table continues to allow IPv4 addresses to allow future
flexibility.  In order to promote a common configuration
this document includes suggestions for default values for
IPv4 prefixes.  Each of these values may be overridden if an
object is meaningful to the node.
          
          
All prefixes used by this entity should be included in this
table independent of how the entity learned the prefix.
(This table isn't limited to prefixes learned from router
advertisements.)

The table containing information 
used to construct router advertisements.

This table contains list of routes that are
created by the user to destination networks.

The IP Address Translation table used for mapping from IP
addresses to physical addresses.
          
The Address Translation tables contain the IP address to
'physical' address equivalences.  Some interfaces do not use
translation tables for determining address equivalences
(e.g., DDN-X.25 has an algorithmic method); if all
interfaces are of this type, then the Address Translation
table is empty, i.e., has zero entries.
          
While many protocols may be used to populate this table, ARP
[10] and Neighbor Discovery [4] are the most likely
options.

IPv6 Prefix List table

DHCP Relay for Ipv6 configuration table

DHCP Relay forwarding table.

The RADIUS table (0 to 10 entries).  This
table lists the information of the RADIUS server.

This table contains list of routes that are
created by the user to destination networks
 on the management port.

Ipv6 Destination Cache table

BFD configuration table

This entity's IPV6 Routing table.

IPv6 Default Routers Table.

IPv6 MLD Host Cache Table.

A table that containing information on configured tunnels.

This entity's IPV6 Routing table.

IPv6 Route Pref table. This table and
rcIpNewRoutePrefTable is designed
to obsolete the rcIpRoutePrefTable

This table contains the entries which are 
snooped by different methods.

IPv6 Isis In Filter Nick Name table

IPv6 Isis In Filter Isid Isid table

IPv6 Isis In Filter Nick Name Isid table

IPv6 Isis In Filter Isid List table

IPv6 Isis In Filter Nick Name Isid List table

This table is used to hold next hop addresses on which BFD is enabled.