CISCO-ADSL-CAP-LINE-MIB Table View

Table-centric layout grouping table, row, and column objects.

Standard view Table view

Tables

Rows

Columns

cAdslAtucCapPhysTable

table

.1.3.6.1.4.1.9.9.149.1.2 · 1 row entry · 3 columns

Open in standard view

This table extends the adslAtucPhysTable and contains
enterprise-specific physical layer parameters for the ATU-C
class devices supported by the system.

cAdslAtucCapPhysEntry entry .1.3.6.1.4.1.9.9.149.1.2.1

A set of enterprise-specific physical-layer parameters for an
ATU-C class device supported by the system. There exists an
entry for each ifEntry with an ifType of adsl(94) and an
adslLineCoding of cap(3).

Indexes

IF-MIBifIndex

Column Syntax OID

cAdslAtucCapCurrState

This object specifies the state of the ATU-C transceiver.

The value of this managed is 'idle' for an ATU-C that has
been provisioned, but is not physically present in the system.

Enumeration

Enumerated Values:

1	other
2	idle
3	training
4	steadyState
5	downloading
6	downloadFailed
7	testing

.1.3.6.1.4.1.9.9.149.1.2.1.1

cAdslAtucCapCurrRxGain

This managed object represents the gain applied to the ATU-C
receiver.

The value of this managed object is '0' for an ATU-C that has
been provisioned, but is not physically present in the system.

tenth dBSNMPv2-SMIGauge32

Textual Convention: SNMPv2-SMIGauge32 Unsigned32

Type Constraints:
range: 0..4294967295

.1.3.6.1.4.1.9.9.149.1.2.1.2

cAdslAtucCapCurrRxSnr

This managed object represents the signal-to-noise ratio
measured across the the ATU-C receive pair.

The value of this managed object is '0' for an ATU-C that has
been provisioned, but is not physically p…

tenth dBSNMPv2-SMIGauge32

Textual Convention: SNMPv2-SMIGauge32 Unsigned32

Type Constraints:
range: 0..4294967295

.1.3.6.1.4.1.9.9.149.1.2.1.3

cAdslAturCapPhysTable

table

.1.3.6.1.4.1.9.9.149.1.3 · 1 row entry · 1 columns

Open in standard view

This table extends the adslAturPhysTable and contains
enterprise-specific physical layer parameters for the ATU-R
class devices supported by the system.

cAdslAturCapPhysEntry entry .1.3.6.1.4.1.9.9.149.1.3.1

A set of enterprise-specific physical-layer parameters for an
ATU-R class device supported by the system. There exists an
entry for each ifEntry with an ifType of adsl(94) and an
adslLineCoding of cap(3).

Indexes

IF-MIBifIndex

Column	Syntax	OID
cAdslAturCapCurrRxGain This managed object represents the gain applied to the ATU-R receiver. The value of this managed object is '0' if the corresponding ATU-C has been provisioned, but is not physically present in the system.	tenth dBSNMPv2-SMIGauge32 Textual Convention: SNMPv2-SMIGauge32 `Unsigned32` Type Constraints: `range: 0..4294967295`	`.1.3.6.1.4.1.9.9.149.1.3.1.1`

cAdslAtucCapPerfDataTable

table

.1.3.6.1.4.1.9.9.149.1.6 · 1 row entry · 4 columns

Open in standard view

This table extends the adslAtucPerfDataTable and contains
enterprise-specific physical layer statistics for the ATU-C
class devices supported by the system.

cAdslAtucCapPerfDataEntry entry .1.3.6.1.4.1.9.9.149.1.6.1

A set of enterprise-specific physical-layer statistics for an
ATU-C class device supported by the system. There exists an
entry for each ifEntry with an ifType of adsl(94) and an
adslLineCoding of cap(3).

Indexes

IF-MIBifIndex

Column	Syntax	OID
cAdslAtucCapPerfInitFailures This object specifies the number of line initialization failures relative to sysUpTime.	SNMPv2-SMICounter32 Textual Convention: SNMPv2-SMICounter32 `Unsigned32` Type Constraints: `range: 0..4294967295`	`.1.3.6.1.4.1.9.9.149.1.6.1.1`
cAdslAtucCapPerfCurr15MinInitFailures This object specifies the number of line initialization failures in the current 15-minute interval.	PerfHist-TC-MIBPerfCurrentCount Textual Convention: PerfHist-TC-MIBPerfCurrentCount `Unsigned32`	`.1.3.6.1.4.1.9.9.149.1.6.1.2`
cAdslAtucCapPerfCurr1DayInitFailures This object specifies the number of line initialization failures in the current 1-day interval.	ADSL-TC-MIBAdslPerfCurrDayCount Textual Convention: ADSL-TC-MIBAdslPerfCurrDayCount `Unsigned32`	`.1.3.6.1.4.1.9.9.149.1.6.1.3`
cAdslAtucCapPerfPrev1DayInitFailures This object specifies the number of line initialization failures in the previous 1-day interval.	ADSL-TC-MIBAdslPerfPrevDayCount Textual Convention: ADSL-TC-MIBAdslPerfPrevDayCount `Unsigned32`	`.1.3.6.1.4.1.9.9.149.1.6.1.4`

cAdslAtucCapIntervalTable

table

.1.3.6.1.4.1.9.9.149.1.8 · 1 row entry · 1 columns

Open in standard view

This table extends the adslAtucIntervalTable and contains
enterprise-specific physical layer statistics intervals for
the ATU-C class devices supported by the system.

cAdslAtucCapIntervalEntry entry .1.3.6.1.4.1.9.9.149.1.8.1

A 15-minute interval of enterprise-specific physical-layer
statistics for an ATU-C class device supported by the system.
There exists up to 96 entries for each ifEntry with an ifType
of adsl(94) and an adslLineCoding of…

Indexes

IF-MIBifIndex ADSL-LINE-MIBadslAtucIntervalNumber

Column	Syntax	OID
cAdslAtucCapIntervalInitFailures This object specifies the number of line initialization failures in the interval.	PerfHist-TC-MIBPerfIntervalCount Textual Convention: PerfHist-TC-MIBPerfIntervalCount `Unsigned32`	`.1.3.6.1.4.1.9.9.149.1.8.1.1`

cAdslLineCapConfProfileTable

table

.1.3.6.1.4.1.9.9.149.1.14 · 1 row entry · 14 columns

Open in standard view

This table extends the adslLineConfProfileTable and contains
enterprise-specific ADSL line configuration information.

cAdslLineCapConfProfileEntry entry .1.3.6.1.4.1.9.9.149.1.14.1

A configuration profile containing enterprise-specific ADSL
line configuration information.

Indexes

ADSL-LINE-MIBadslLineConfProfileName

Column Syntax OID

cAdslLineCapConfTrainingMode

This object specifies the mode employed by the ATU-C and
ATU-R when training against each other. One of two training
modes can be employed:

- Standard
An ATU-C initiates a training sequence using the…

Enumerationr/w

Enumerated Values:

1	standard
2	fast

.1.3.6.1.4.1.9.9.149.1.14.1.1

cAdslLineCapConfInterleaveDelay

This object specifies the interleave delay for the
downstream channel. The value of this object specifies the
mapping (relative spacing) between subsequent input bytes at
the interleaver input and their placement in th…

Enumerationr/w

Enumerated Values:

1	none
2	short
3	long

.1.3.6.1.4.1.9.9.149.1.14.1.2

cAdslLineCapConfCpeSignature

This object specifies the value of the minimum CPE signature
expected from ATU-R during training. The value of the CPE
signature corresponds to the software version of the ATU-R.

If the CPE signature adv…

Integer32r/w

Constraints:
range: 0-127

.1.3.6.1.4.1.9.9.149.1.14.1.3

cAdslAtucCapConfTargetSnrMgn

This object specifies the target SNR margin. This is the
desired noise margin the ATU-C must achieve with a BER of
10-7 or better to successfully complete training.

tenth dBInteger32r/w

Constraints:
range: 0-310

.1.3.6.1.4.1.9.9.149.1.14.1.4

cAdslAtucCapConfMinTxRate

This object specifies the minimum acceptable downstream
line rate.

bpsAdslLineCapDownstreamRater/w

Textual Convention: AdslLineCapDownstreamRate Integer32

Type Constraints:
range: 0
range: 256000
range: 384000
range: 512000
range: 640000
range: 768000
range: 896000
range: 960000
range: 1024000
range: 1280000
range: 1600000
range: 1920000
range: 2240000
range: 2560000
range: 2688000
range: 3200000
range: 4480000
range: 5120000
range: 6272000
range: 7168000

.1.3.6.1.4.1.9.9.149.1.14.1.5

cAdslAtucCapConfMaxTxRate

This object specifies the desired line rate which the ATU-C
will attempt to train at.

bpsAdslLineCapDownstreamRater/w

Textual Convention: AdslLineCapDownstreamRate Integer32

.1.3.6.1.4.1.9.9.149.1.14.1.6

cAdslAtucCapConfDown136KBaudEnable

This object specifies whether the modem can train the
downstream channel using a symbol rate of 136K symbols
per second.

SNMPv2-TCTruthValuer/w

Textual Convention: SNMPv2-TCTruthValue Enumeration

Type Values:

1	true
2	false

.1.3.6.1.4.1.9.9.149.1.14.1.7

cAdslAtucCapConfUp68KBaudEnable

This object specifies whether the modem can train the
upstream channel using a symbol rate of 68K symbols
per second.

The value of this object does not effect whether the modem
can train at any other symb…

SNMPv2-TCTruthValuer/w

Textual Convention: SNMPv2-TCTruthValue Enumeration

Type Values:

1	true
2	false

.1.3.6.1.4.1.9.9.149.1.14.1.8

cAdslAtucCapConfUp17KBaudEnable

This object specifies whether the modem can train the
upstream channel using a symbol rate of 17K symbols
per second.

The value of this object does not effect whether the modem
can train at any other symb…

SNMPv2-TCTruthValuer/w

Textual Convention: SNMPv2-TCTruthValue Enumeration

Type Values:

1	true
2	false

.1.3.6.1.4.1.9.9.149.1.14.1.9

cAdslAtucCapConfPsdmLevel

This managed object specifies the nominal power output of the
ATU-C across the entire transmit spectrum. Observe that this
implies the attenuation of the signal for some data rates.

This value does not t…

dBm/HzInteger32r/w

Constraints:
range: -52--52
range: -49--49
range: -46--46
range: -43--43
range: -40--40
range: -37--37

.1.3.6.1.4.1.9.9.149.1.14.1.10

cAdslAturCapConfTargetSnrMgn

This object specifies the target SNR margin. This is the
desired noise margin the ATU-R must achieve with a BER of
10-7 or better to successfully complete training.

tenth dBInteger32r/w

Constraints:
range: 0-310

.1.3.6.1.4.1.9.9.149.1.14.1.11

cAdslAturCapConfMinTxRate

This object specifies the minimum acceptable upstream
line rate.

bpsAdslLineCapUpstreamRater/w

Textual Convention: AdslLineCapUpstreamRate Integer32

Type Constraints:
range: 0
range: 91000
range: 272000
range: 408000
range: 544000
range: 680000
range: 816000
range: 952000
range: 1088000

.1.3.6.1.4.1.9.9.149.1.14.1.12

cAdslAturCapConfMaxTxRate

This object specifies the desired line rate which the ATU-R
will attempt to train at.

bpsAdslLineCapUpstreamRater/w

Textual Convention: AdslLineCapUpstreamRate Integer32

Type Constraints:
range: 0
range: 91000
range: 272000
range: 408000
range: 544000
range: 680000
range: 816000
range: 952000
range: 1088000

.1.3.6.1.4.1.9.9.149.1.14.1.13

cAdslAturCapConfPsdmLevel

This managed object specifies the nominal power output of the
ATU-R across the entire transmit spectrum. Observe that this
implies the attenuation of the signal for some data rates.

This value does not t…

dBm/HzInteger32r/w

Constraints:
range: -53--53
range: -50--50
range: -47--47
range: -44--44
range: -41--41
range: -38--38

.1.3.6.1.4.1.9.9.149.1.14.1.14