cAdslAtucCapConfTargetSnrMgn
CISCO-ADSL-CAP-LINE-MIB ·
.1.3.6.1.4.1.9.9.149.1.14.1.4
Object
column
r/w
tenth dB Integer32
This object specifies the target SNR margin. This is the desired noise margin the ATU-C must achieve with a BER of 10-7 or better to successfully complete training.
Context
- MIB
- CISCO-ADSL-CAP-LINE-MIB
- OID
.1.3.6.1.4.1.9.9.149.1.14.1.4- Type
- column
- Access
- readwrite
- Status
- current
- Units
- tenth dB
- Parent
- cAdslLineCapConfProfileEntry
- Table
- cAdslLineCapConfProfileTable
- Siblings
- 13
Syntax
tenth dB Integer32
Values & Constraints
Object Constraints
range: 0-310
Related Objects
Sibling Objects
| Object | Type | Syntax | OID |
|---|---|---|---|
| cAdslLineCapConfTrainingMode This object specifies the mode employed by the ATU-C and
ATU-R when training against each other. One of two training
modes can be employed:
- Standard
An ATU-C… | column | Enumeration | .1.3.6.1.4.1.9.9.149.1.14.1.1 |
| cAdslAtucCapConfPsdmLevel This managed object specifies the nominal power output of the
ATU-C across the entire transmit spectrum. Observe that this
implies the attenuation of the signal for some data rat… | column | dBm/Hz Integer32 | .1.3.6.1.4.1.9.9.149.1.14.1.10 |
| cAdslAturCapConfTargetSnrMgn This object specifies the target SNR margin. This is the
desired noise margin the ATU-R must achieve with a BER of
10-7 or better to successfully complete training. | column | tenth dB Integer32 | .1.3.6.1.4.1.9.9.149.1.14.1.11 |
| cAdslAturCapConfMinTxRate This object specifies the minimum acceptable upstream
line rate. | column | bps AdslLineCapUpstreamRate | .1.3.6.1.4.1.9.9.149.1.14.1.12 |
| cAdslAturCapConfMaxTxRate This object specifies the desired line rate which the ATU-R
will attempt to train at. | column | bps AdslLineCapUpstreamRate | .1.3.6.1.4.1.9.9.149.1.14.1.13 |
| cAdslAturCapConfPsdmLevel This managed object specifies the nominal power output of the
ATU-R across the entire transmit spectrum. Observe that this
implies the attenuation of the signal for some data rat… | column | dBm/Hz Integer32 | .1.3.6.1.4.1.9.9.149.1.14.1.14 |
| cAdslLineCapConfInterleaveDelay This object specifies the interleave delay for the
downstream channel. The value of this object specifies the
mapping (relative spacing) between subsequent input bytes at
the int… | column | Enumeration | .1.3.6.1.4.1.9.9.149.1.14.1.2 |
| cAdslLineCapConfCpeSignature This object specifies the value of the minimum CPE signature
expected from ATU-R during training. The value of the CPE
signature corresponds to the software version of the ATU-R.… | column | Integer32 | .1.3.6.1.4.1.9.9.149.1.14.1.3 |
| cAdslAtucCapConfMinTxRate This object specifies the minimum acceptable downstream
line rate. | column | bps AdslLineCapDownstreamRate | .1.3.6.1.4.1.9.9.149.1.14.1.5 |
| cAdslAtucCapConfMaxTxRate This object specifies the desired line rate which the ATU-C
will attempt to train at. | column | bps AdslLineCapDownstreamRate | .1.3.6.1.4.1.9.9.149.1.14.1.6 |
| cAdslAtucCapConfDown136KBaudEnable This object specifies whether the modem can train the
downstream channel using a symbol rate of 136K symbols
per second. | column | SNMPv2-TCTruthValue | .1.3.6.1.4.1.9.9.149.1.14.1.7 |
| cAdslAtucCapConfUp68KBaudEnable This object specifies whether the modem can train the
upstream channel using a symbol rate of 68K symbols
per second.
The value of this object does not effect wheth… | column | SNMPv2-TCTruthValue | .1.3.6.1.4.1.9.9.149.1.14.1.8 |
| cAdslAtucCapConfUp17KBaudEnable This object specifies whether the modem can train the
upstream channel using a symbol rate of 17K symbols
per second.
The value of this object does not effect wheth… | column | SNMPv2-TCTruthValue | .1.3.6.1.4.1.9.9.149.1.14.1.9 |