cAdslLineCapConfInterleaveDelay
CISCO-ADSL-CAP-LINE-MIB ·
.1.3.6.1.4.1.9.9.149.1.14.1.2
Object
column
r/w
Enumeration
This object specifies the interleave delay for the downstream channel. The value of this object specifies the mapping (relative spacing) between subsequent input bytes at the interleaver input and their placement in the bit stream at the interleaver output. The value 'long' provides greater separation between consecutive input bytes in the output bit stream, thereby allowing for improved impulse noise immunity at the expense of payload latency.
Context
- MIB
- CISCO-ADSL-CAP-LINE-MIB
- OID
.1.3.6.1.4.1.9.9.149.1.14.1.2- Type
- column
- Access
- readwrite
- Status
- current
- Parent
- cAdslLineCapConfProfileEntry
- Table
- cAdslLineCapConfProfileTable
- Siblings
- 13
Syntax
Enumeration
Values & Constraints
Enumerated Values
1 | none |
2 | short |
3 | long |
Related Objects
Sibling Objects
| Object | Type | Syntax | OID |
|---|---|---|---|
| cAdslLineCapConfTrainingMode This object specifies the mode employed by the ATU-C and
ATU-R when training against each other. One of two training
modes can be employed:
- Standard
An ATU-C… | column | Enumeration | .1.3.6.1.4.1.9.9.149.1.14.1.1 |
| cAdslAtucCapConfPsdmLevel This managed object specifies the nominal power output of the
ATU-C across the entire transmit spectrum. Observe that this
implies the attenuation of the signal for some data rat… | column | dBm/Hz Integer32 | .1.3.6.1.4.1.9.9.149.1.14.1.10 |
| cAdslAturCapConfTargetSnrMgn This object specifies the target SNR margin. This is the
desired noise margin the ATU-R must achieve with a BER of
10-7 or better to successfully complete training. | column | tenth dB Integer32 | .1.3.6.1.4.1.9.9.149.1.14.1.11 |
| cAdslAturCapConfMinTxRate This object specifies the minimum acceptable upstream
line rate. | column | bps AdslLineCapUpstreamRate | .1.3.6.1.4.1.9.9.149.1.14.1.12 |
| cAdslAturCapConfMaxTxRate This object specifies the desired line rate which the ATU-R
will attempt to train at. | column | bps AdslLineCapUpstreamRate | .1.3.6.1.4.1.9.9.149.1.14.1.13 |
| cAdslAturCapConfPsdmLevel This managed object specifies the nominal power output of the
ATU-R across the entire transmit spectrum. Observe that this
implies the attenuation of the signal for some data rat… | column | dBm/Hz Integer32 | .1.3.6.1.4.1.9.9.149.1.14.1.14 |
| cAdslLineCapConfCpeSignature This object specifies the value of the minimum CPE signature
expected from ATU-R during training. The value of the CPE
signature corresponds to the software version of the ATU-R.… | column | Integer32 | .1.3.6.1.4.1.9.9.149.1.14.1.3 |
| cAdslAtucCapConfTargetSnrMgn This object specifies the target SNR margin. This is the
desired noise margin the ATU-C must achieve with a BER of
10-7 or better to successfully complete training. | column | tenth dB Integer32 | .1.3.6.1.4.1.9.9.149.1.14.1.4 |
| cAdslAtucCapConfMinTxRate This object specifies the minimum acceptable downstream
line rate. | column | bps AdslLineCapDownstreamRate | .1.3.6.1.4.1.9.9.149.1.14.1.5 |
| cAdslAtucCapConfMaxTxRate This object specifies the desired line rate which the ATU-C
will attempt to train at. | column | bps AdslLineCapDownstreamRate | .1.3.6.1.4.1.9.9.149.1.14.1.6 |
| cAdslAtucCapConfDown136KBaudEnable This object specifies whether the modem can train the
downstream channel using a symbol rate of 136K symbols
per second. | column | SNMPv2-TCTruthValue | .1.3.6.1.4.1.9.9.149.1.14.1.7 |
| cAdslAtucCapConfUp68KBaudEnable This object specifies whether the modem can train the
upstream channel using a symbol rate of 68K symbols
per second.
The value of this object does not effect wheth… | column | SNMPv2-TCTruthValue | .1.3.6.1.4.1.9.9.149.1.14.1.8 |
| cAdslAtucCapConfUp17KBaudEnable This object specifies whether the modem can train the
upstream channel using a symbol rate of 17K symbols
per second.
The value of this object does not effect wheth… | column | SNMPv2-TCTruthValue | .1.3.6.1.4.1.9.9.149.1.14.1.9 |