cAdslLineCapConfCpeSignature
CISCO-ADSL-CAP-LINE-MIB ·
.1.3.6.1.4.1.9.9.149.1.14.1.3
Object
column
r/w
Integer32
This object specifies the value of the minimum CPE signature
expected from ATU-R during training. The value of the CPE
signature corresponds to the software version of the ATU-R.
If the CPE signature advertised by an ATU-R is less than the
value of this object, then the ATU-C will be placed into an
idle state, thereby preventing the line from training.
In addition, the agent increments the value of the
cAdslAtucCapPerfInitFailures object for each attempt to train
by an ATU-R advertising a CPE signature less than the value of
this object. When a management client observes the value of
cAdslAtucCapPerfInitFailures increasing, it should retrieve the
value of the adslAturInvSerialNumber object (for more details,
see the ADSL-LINE-MIB) . This value of this object reflects the
CPE signature advertised by an ATU-R implementing the CAP line
code. If the CPE signature of the ATU-R is not known, the value
of the adslAturInvSerialNumber object should be a zero-length
string.
Context
- MIB
- CISCO-ADSL-CAP-LINE-MIB
- OID
.1.3.6.1.4.1.9.9.149.1.14.1.3- Type
- column
- Access
- readwrite
- Status
- current
- Parent
- cAdslLineCapConfProfileEntry
- Table
- cAdslLineCapConfProfileTable
- Siblings
- 13
Syntax
Integer32
Values & Constraints
Object Constraints
range: 0-127
Related Objects
Sibling Objects
| Object | Type | Syntax | OID |
|---|---|---|---|
| cAdslLineCapConfTrainingMode This object specifies the mode employed by the ATU-C and
ATU-R when training against each other. One of two training
modes can be employed:
- Standard
An ATU-C… | column | Enumeration | .1.3.6.1.4.1.9.9.149.1.14.1.1 |
| cAdslAtucCapConfPsdmLevel This managed object specifies the nominal power output of the
ATU-C across the entire transmit spectrum. Observe that this
implies the attenuation of the signal for some data rat… | column | dBm/Hz Integer32 | .1.3.6.1.4.1.9.9.149.1.14.1.10 |
| cAdslAturCapConfTargetSnrMgn This object specifies the target SNR margin. This is the
desired noise margin the ATU-R must achieve with a BER of
10-7 or better to successfully complete training. | column | tenth dB Integer32 | .1.3.6.1.4.1.9.9.149.1.14.1.11 |
| cAdslAturCapConfMinTxRate This object specifies the minimum acceptable upstream
line rate. | column | bps AdslLineCapUpstreamRate | .1.3.6.1.4.1.9.9.149.1.14.1.12 |
| cAdslAturCapConfMaxTxRate This object specifies the desired line rate which the ATU-R
will attempt to train at. | column | bps AdslLineCapUpstreamRate | .1.3.6.1.4.1.9.9.149.1.14.1.13 |
| cAdslAturCapConfPsdmLevel This managed object specifies the nominal power output of the
ATU-R across the entire transmit spectrum. Observe that this
implies the attenuation of the signal for some data rat… | column | dBm/Hz Integer32 | .1.3.6.1.4.1.9.9.149.1.14.1.14 |
| cAdslLineCapConfInterleaveDelay This object specifies the interleave delay for the
downstream channel. The value of this object specifies the
mapping (relative spacing) between subsequent input bytes at
the int… | column | Enumeration | .1.3.6.1.4.1.9.9.149.1.14.1.2 |
| cAdslAtucCapConfTargetSnrMgn This object specifies the target SNR margin. This is the
desired noise margin the ATU-C must achieve with a BER of
10-7 or better to successfully complete training. | column | tenth dB Integer32 | .1.3.6.1.4.1.9.9.149.1.14.1.4 |
| cAdslAtucCapConfMinTxRate This object specifies the minimum acceptable downstream
line rate. | column | bps AdslLineCapDownstreamRate | .1.3.6.1.4.1.9.9.149.1.14.1.5 |
| cAdslAtucCapConfMaxTxRate This object specifies the desired line rate which the ATU-C
will attempt to train at. | column | bps AdslLineCapDownstreamRate | .1.3.6.1.4.1.9.9.149.1.14.1.6 |
| cAdslAtucCapConfDown136KBaudEnable This object specifies whether the modem can train the
downstream channel using a symbol rate of 136K symbols
per second. | column | SNMPv2-TCTruthValue | .1.3.6.1.4.1.9.9.149.1.14.1.7 |
| cAdslAtucCapConfUp68KBaudEnable This object specifies whether the modem can train the
upstream channel using a symbol rate of 68K symbols
per second.
The value of this object does not effect wheth… | column | SNMPv2-TCTruthValue | .1.3.6.1.4.1.9.9.149.1.14.1.8 |
| cAdslAtucCapConfUp17KBaudEnable This object specifies whether the modem can train the
upstream channel using a symbol rate of 17K symbols
per second.
The value of this object does not effect wheth… | column | SNMPv2-TCTruthValue | .1.3.6.1.4.1.9.9.149.1.14.1.9 |