RFC1315-MIB Table View

The Parameters for the Data Link Connection Management
Interface for the frame relay service on this
interface.

frDlcmiEntry row .1.3.6.1.2.1.10.32.1.1

The Parameters for a particular Data Link Con-
nection Management Interface.

Indexes

frDlcmiIfIndex

Column	Syntax	OID
frDlcmiIfIndexmandatory The ifIndex value of the corresponding ifEn- try.	Integer32 Type Constraints: range: -2147483648..2147483647	.1.3.6.1.2.1.10.32.1.1.1
frDlcmiStatemandatory This variable states which Data Link Connec- tion Management scheme is active (and by impli- cation, what DLCI it uses) on the Frame Relay interface.	Enumerationr/w Enumerated Values: 1 noLmiConfigured 2 lmiRev1 3 ansiT1-617-D 4 ansiT1-617-B 5 q933a 6 original-lmi	.1.3.6.1.2.1.10.32.1.1.2
frDlcmiAddressmandatory This variable states which address format is in use on the Frame Relay interface.	Enumerationr/w Enumerated Values: 1 q921 2 q922March90 3 q922November90 4 q922	.1.3.6.1.2.1.10.32.1.1.3
frDlcmiAddressLenmandatory This variable states which address length in octets. In the case of Q922 format, the length indicates the entire length of the address in- cluding the control portion.	Enumerationr/w Enumerated Values: 2 two-octets 3 three-octets 4 four-octets	.1.3.6.1.2.1.10.32.1.1.4
frDlcmiPollingIntervalmandatory This is the number of seconds between succes- sive status enquiry messages.	Integer32r/w Constraints: range: 5-30	.1.3.6.1.2.1.10.32.1.1.5
frDlcmiFullEnquiryIntervalmandatory Number of status enquiry intervals that pass before issuance of a full status enquiry mes- sage.	Integer32r/w Constraints: range: 1-255	.1.3.6.1.2.1.10.32.1.1.6
frDlcmiErrorThresholdmandatory This is the maximum number of unanswered Status Enquiries the equipment shall accept be- fore declaring the interface down.	Integer32r/w Constraints: range: 1-10	.1.3.6.1.2.1.10.32.1.1.7
frDlcmiMonitoredEventsmandatory This is the number of status polling intervals over which the error threshold is counted. For example, if within 'MonitoredEvents' number of events the station receives 'ErrorThreshold' number of errors, the interf…	Integer32r/w Constraints: range: 1-10	.1.3.6.1.2.1.10.32.1.1.8
frDlcmiMaxSupportedVCsmandatory The maximum number of Virtual Circuits allowed for this interface. Usually dictated by the Frame Relay network. In response to a SET, if a value less than zero or higher than the agent's maximal cap…	Integer32r/w Constraints: range: 0-1023	.1.3.6.1.2.1.10.32.1.1.9
frDlcmiMulticastmandatory This indicates whether the Frame Relay inter- face is using a multicast service.	Enumerationr/w Enumerated Values: 1 nonBroadcast 2 broadcast	.1.3.6.1.2.1.10.32.1.1.10
frDlcmiDceIdleIntervalmandatory This is the number of seconds within a status enquiry messages should be received.	Integer32r/w Constraints: range: 10-60	.1.3.6.1.2.1.10.32.1.1.42
frDlcmiDceErrorThresholdmandatory This is the maximum number of unsent Status Enquiries the equipment shall accept be- fore declaring the interface down.	Integer32r/w Constraints: range: 1-10	.1.3.6.1.2.1.10.32.1.1.43
frDlcmiDceMonitoredEventsmandatory This is the number of status polling intervals over which the error threshold is counted. For example, if within 'MonitoredEvents' number of events the station receives 'ErrorThreshold' number of errors, the interf…	Integer32r/w Constraints: range: 1-10	.1.3.6.1.2.1.10.32.1.1.44
frDlcmiModemandatory This indicates the mode of the interface. dte(1) does status enquiry polling, dce(2) does status answering. nni(3) is bidirectional use of both dte and dce.	Enumerationr/w Enumerated Values: 1 dte 2 dce 3 nni	.1.3.6.1.2.1.10.32.1.1.45
frDlcmiDefaultRouteIfIndexmandatory This is the default route interface index when a new PVC is established by means of line management.	Integer32r/w Type Constraints: range: -2147483648..2147483647	.1.3.6.1.2.1.10.32.1.1.46

A table containing information about specific Data
Link Connection Identifiers and corresponding virtual
circuits.

frCircuitEntry row .1.3.6.1.2.1.10.32.2.1

The information regarding a single Data Link
Connection Identifier.

Indexes

frCircuitIfIndex frCircuitDlci

Column	Syntax	OID
frCircuitIfIndexmandatory The ifIndex Value of the ifEntry this virtual circuit is layered onto.	Integer32r/w Type Constraints: range: -2147483648..2147483647	.1.3.6.1.2.1.10.32.2.1.1
frCircuitDlcimandatory The Data Link Connection Identifier for this virtual circuit.	Integer32r/w Type Constraints: range: -2147483648..2147483647	.1.3.6.1.2.1.10.32.2.1.2
frCircuitStatemandatory Indicates whether the particular virtual cir- cuit is operational. In the absence of a Data Link Connection Management Interface, virtual circuit entries (rows) may be created by set- ting virtual circuit state…	Enumerationr/w Enumerated Values: 1 invalid 2 active 3 inactive	.1.3.6.1.2.1.10.32.2.1.3
frCircuitReceivedFECNsmandatory Number of frames received from the network in- dicating forward congestion since the virtual circuit was created.	RFC1155-SMICounter Type Constraints: range: 0..4294967295	.1.3.6.1.2.1.10.32.2.1.4
frCircuitReceivedBECNsmandatory Number of frames received from the network in- dicating backward congestion since the virtual circuit was created.	RFC1155-SMICounter Type Constraints: range: 0..4294967295	.1.3.6.1.2.1.10.32.2.1.5
frCircuitSentFramesmandatory The number of frames sent from this virtual circuit since it was created.	RFC1155-SMICounter Type Constraints: range: 0..4294967295	.1.3.6.1.2.1.10.32.2.1.6
frCircuitSentOctetsmandatory The number of octets sent from this virtual circuit since it was created.	RFC1155-SMICounter Type Constraints: range: 0..4294967295	.1.3.6.1.2.1.10.32.2.1.7
frCircuitReceivedFramesmandatory Number of frames received over this virtual circuit since it was created.	RFC1155-SMICounter Type Constraints: range: 0..4294967295	.1.3.6.1.2.1.10.32.2.1.8
frCircuitReceivedOctetsmandatory Number of octets received over this virtual circuit since it was created.	RFC1155-SMICounter Type Constraints: range: 0..4294967295	.1.3.6.1.2.1.10.32.2.1.9
frCircuitCreationTimemandatory The value of sysUpTime when the virtual cir- cuit was created, whether by the Data Link Con- nection Management Interface or by a SetRe- quest.	RFC1155-SMITimeTicks Type Constraints: range: 0..4294967295	.1.3.6.1.2.1.10.32.2.1.10
frCircuitLastTimeChangemandatory The value of sysUpTime when last there was a change in the virtual circuit state	RFC1155-SMITimeTicks Type Constraints: range: 0..4294967295	.1.3.6.1.2.1.10.32.2.1.11
frCircuitCommittedBurstmandatory This variable indicates the maximum amount of data, in bits, that the network agrees to transfer under normal conditions, during the measurement interval.	Integer32r/w Type Constraints: range: -2147483648..2147483647	.1.3.6.1.2.1.10.32.2.1.12
frCircuitExcessBurstmandatory This variable indicates the maximum amount of uncommitted data bits that the network will at- tempt to deliver over the measurement interval. By default, if not configured when creating the entry, the Ex…	Integer32r/w Type Constraints: range: -2147483648..2147483647	.1.3.6.1.2.1.10.32.2.1.13
frCircuitThroughputmandatory Throughput is the average number of 'Frame Re- lay Information Field' bits transferred per second across a user network interface in one direction, measured over the measurement inter- val. If the …	Integer32r/w Type Constraints: range: -2147483648..2147483647	.1.3.6.1.2.1.10.32.2.1.14
frCircuitRouteTypemandatory Type of routing entry. This field is intended for informational purpose only.	Enumeration Enumerated Values: 1 local 2 switch	.1.3.6.1.2.1.10.32.2.1.42
frCircuitRouteIfIndexmandatory The destination IfIndex is a pointer to either a second frame relay interface (frame relay switching) or to a frame relay virtual interface (multiprotocol routing).	Integer32r/w Type Constraints: range: -2147483648..2147483647	.1.3.6.1.2.1.10.32.2.1.43
frCircuitRouteDlcimandatory The destination DLCI. When the circuit is used for switching, all packets are sent using this DLCI. This field is void for multiprotocol routing.	Integer32r/w Type Constraints: range: -2147483648..2147483647	.1.3.6.1.2.1.10.32.2.1.44

A table containing information about Errors on the
Frame Relay interface.

frErrEntry row .1.3.6.1.2.1.10.32.3.1

The error information for a single frame relay
interface.

Indexes

frErrIfIndex

Column	Syntax	OID
frErrIfIndexmandatory The ifIndex Value of the corresponding ifEn- try.	Integer32 Type Constraints: range: -2147483648..2147483647	.1.3.6.1.2.1.10.32.3.1.1
frErrTypemandatory The type of error that was last seen on this interface.	Enumeration Enumerated Values: 1 unknownError 2 receiveShort 3 receiveLong 4 illegalDLCI 5 unknownDLCI 6 dlcmiProtoErr 7 dlcmiUnknownIE 8 dlcmiSequenceErr 9 dlcmiUnknownRpt 10 noErrorSinceReset	.1.3.6.1.2.1.10.32.3.1.2
frErrDatamandatory An octet string containing as much of the er- ror packet as possible. As a minimum, it must contain the Q.922 Address or as much as was delivered. It is desirable to include all in- formation up to the PDU.	OctetString	.1.3.6.1.2.1.10.32.3.1.3
frErrTimemandatory The value of sysUpTime at which the error was detected.	RFC1155-SMITimeTicks Type Constraints: range: 0..4294967295	.1.3.6.1.2.1.10.32.3.1.4