currentDropDetection

SDEVICE-MIB · .1.3.6.1.4.1.31034.2.7.1.11
MIB view Table view

Object

scalar r/w Integer32 
Enables the current drop detection function. 0 = always off
(default), 1 = input (s) only, 2 = output(s) only, 3 = both
inputs and outputs.

Context

MIB
SDEVICE-MIB
OID
.1.3.6.1.4.1.31034.2.7.1.11
Type
scalar
Access
readwrite
Status
current
Parent
general
Siblings
8

Syntax

Integer32

Values & Constraints

Object Constraints
range: 0-3

Related Objects

Sibling Objects
ObjectTypeSyntaxOID
localAlertReset
Allow alerts to be reset locally on device by pushing one of the buttons. [replaces dipDuration]
scalarSNMPv2-SMIInteger32.1.3.6.1.4.1.31034.2.7.1.10
wirelessDisplayPower
Controls the transit power of the wireless display transciever (if installed). Set to zero to completely disable the module.
scalarSNMPv2-SMIInteger32.1.3.6.1.4.1.31034.2.7.1.12
peakDuration
A current peak should last at least [stpkdr] MilliSeconds before an alert is raised; max about a minute.
scalarMilliSeconds.1.3.6.1.4.1.31034.2.7.1.4
fixedOutletDelay
Minimal delay between two successive relay switches in milliseconds. Minimal delay is 100 ms. Will always be respected!
scalarMilliSeconds.1.3.6.1.4.1.31034.2.7.1.5
powerSaverMode
Set backlight on time in seconds; 0 keeps display always on. Note that keeping the backlight on may decrease luminosity over time. Setting this to other values than 10, 60, 120 or…
scalarSeconds.1.3.6.1.4.1.31034.2.7.1.6
outletPowerupMode
Behaviour of outlet on power-up: 0=off; 1=same state as at power down; 2=same state, but delayed by individual delay timer.
scalarInteger32.1.3.6.1.4.1.31034.2.7.1.7
maximumTemperature
An alert should be generated whenever the temperature of the first connected T sensor is above this value. Zero means disabled.
scalarInteger32.1.3.6.1.4.1.31034.2.7.1.8
displayOrientation
0 no display; display off; 1 vertical, display on top; 2 vertical, upside down; 3 horizontal, display at left; 4 horizontal, display at right
scalarInteger32.1.3.6.1.4.1.31034.2.7.1.9