ruckusWLANBeaconPeriod
RUCKUS-WLAN-MIB ·
.1.3.6.1.4.1.25053.1.1.6.1.1.1.1.1.5
Object
column
milli seconds Integer32
This attribute shall specify the number of milli seconds that a station shall use for scheduling Beacon transmissions. This value is transmitted in Beacon and Probe Response frames.
Context
- MIB
- RUCKUS-WLAN-MIB
- OID
.1.3.6.1.4.1.25053.1.1.6.1.1.1.1.1.5- Type
- column
- Access
- readonly
- Status
- current
- Units
- milli seconds
- Parent
- ruckusWLANEntry
- Table
- ruckusWLANTable
- Siblings
- 18
Syntax
milli seconds Integer32
Values & Constraints
Object Constraints
range: 100-1000
Related Objects
Sibling Objects
| Object | Type | Syntax | OID |
|---|---|---|---|
| ruckusWLANSSID Specifies the name of the SSID. | column | RUCKUS-TC-MIBRuckusSSID | .1.3.6.1.4.1.25053.1.1.6.1.1.1.1.1.1 |
| ruckusWLANChannel Specifies the current operating channel. | column | Integer32 | .1.3.6.1.4.1.25053.1.1.6.1.1.1.1.1.10 |
| ruckusWLANWDSEnable Specifies if the WDS is enabled or disabled on this interface.
Allow 4 address mode of operation for an given WLAN interface. | column | SNMPv2-TCTruthValue | .1.3.6.1.4.1.25053.1.1.6.1.1.1.1.1.11 |
| ruckusWLANAdminStatus Administrative status of the WLAN interface. | column | Enumeration | .1.3.6.1.4.1.25053.1.1.6.1.1.1.1.1.12 |
| ruckusWLANProtectionMode Enabled when 11g and 11b clients exist on the same network.
none:
Do not use any protection
ctsOnly:
AP will send a CTS frame prior to sending 11g frames.
The CTS f… | column | Enumeration | .1.3.6.1.4.1.25053.1.1.6.1.1.1.1.1.13 |
| ruckusWLANName Specifies the name of the wlan. | column | OctetString | .1.3.6.1.4.1.25053.1.1.6.1.1.1.1.1.14 |
| ruckusWLANSSIDBcastDisable Setting to 1, cause the ssid will not be broadcast in the beacons. | column | SNMPv2-TCTruthValue | .1.3.6.1.4.1.25053.1.1.6.1.1.1.1.1.15 |
| ruckusWLANVlanID Specifies the VLAN ID of the WLAN. If VLAN ID is 1, packets from this WLAN will be untagged. | column | Integer32 | .1.3.6.1.4.1.25053.1.1.6.1.1.1.1.1.16 |
| ruckusWLANRateShaper This is controls fair access to the network. When enabled, the network traffic throughput
of each network device is limited to the rate specified in the traffic policy. Configura… | column | OctetString | .1.3.6.1.4.1.25053.1.1.6.1.1.1.1.1.17 |
| ruckusWLANBSSID This attribute is the unique identifier in this BSS.
It is the 48-bit MAC address of the wireless interface. | column | SNMPv2-TCMacAddress | .1.3.6.1.4.1.25053.1.1.6.1.1.1.1.1.2 |
| ruckusWLANIfIndex Interface index. | column | SNMPv2-SMIUnsigned32 | .1.3.6.1.4.1.25053.1.1.6.1.1.1.1.1.200 |
| ruckusWLANIGMPSnooping Configure the IGMPSnooping for this WLAN. | column | Enumeration | .1.3.6.1.4.1.25053.1.1.6.1.1.1.1.1.25 |
| ruckusWLANBSSType Specifies the bss type. | column | Enumeration | .1.3.6.1.4.1.25053.1.1.6.1.1.1.1.1.3 |
| ruckusWLANOperationalRateSet This attribute shall specify the set of data rates
at which the station may transmit data. Each octet
contains a value representing a rate. Each rate
shall be within the range f… | column | OctetString | .1.3.6.1.4.1.25053.1.1.6.1.1.1.1.1.4 |
| ruckusWLANDTIMPeriod This attribute shall specify the number of TU that a
station shall use for scheduling Beacon transmissions.
This value is transmitted in Beacon and Probe Response
frames. | column | Integer32 | .1.3.6.1.4.1.25053.1.1.6.1.1.1.1.1.6 |
| ruckusWLANRTSThreshold This attribute shall indicate the number of octets in an
MPDU, below which an RTS/CTS handshake shall not be
performed, except as RTS/CTS is used as a cross modulation
protection … | column | Integer32 | .1.3.6.1.4.1.25053.1.1.6.1.1.1.1.1.7 |
| ruckusWLANFragmentationThreshold This attribute shall specify the current maximum size, in
octets, of the MPDU that may be delivered to the PHY.
An MSDU shall be broken into fragments if its size exceeds
the valu… | column | Integer32 | .1.3.6.1.4.1.25053.1.1.6.1.1.1.1.1.8 |
| ruckusWLANRadioMode Specifies the radio mode. | column | Enumeration | .1.3.6.1.4.1.25053.1.1.6.1.1.1.1.1.9 |