pdnAdslLineL2Atpr
PDN-ADSL-LINE-EXT-MIB ·
.1.3.6.1.4.1.1795.2.24.2.6.24.1.1.1.9
Object
column
r/w
dB Unsigned32
The maximum aggregate transmit power reduction, in dB, that can
be performed through a single Power Trim in the L2 state.
At the time this MIB was produced, the upper limit for this object
was not updated in the G.997.1 with respect to ADSL2plus. As such,
the upper limit of this object should be defined in an implementation-
specific document such as an Operational Specification.
Context
- MIB
- PDN-ADSL-LINE-EXT-MIB
- OID
.1.3.6.1.4.1.1795.2.24.2.6.24.1.1.1.9- Type
- column
- Access
- readwrite
- Status
- current
- Units
- dB
- Parent
- pdnAdslLineExtEntry
- Table
- pdnAdslLineExtTable
- Siblings
- 10
Syntax
dB Unsigned32
Values & Constraints
Object Constraints
range: 0-31
Related Objects
Sibling Objects
| Object | Type | Syntax | OID |
|---|---|---|---|
| pdnAdslLineTransAtucCap The transmission modes, represented by a bitmask that the
ATU-C is capable of supporting. The modes available are
limited by the design of the equipment. | column | PdnAdslTransmissionModeType | .1.3.6.1.4.1.1795.2.24.2.6.24.1.1.1.1 |
| pdnAdslLineLdsf Defines whether the line should be forced into the loop
diagnostics mode by the near-end ATU on this line.
ldsfMode0(1) - 0: Inhibits the near-end ATU from performing loop
… | column | Enumeration | .1.3.6.1.4.1.1795.2.24.2.6.24.1.1.1.10 |
| pdnAdslLineL2Atprt This parameter represents the total maximum aggregate transmit
power reduction (in dB) that can be performed in an L2 state.
This is the sum of all reductions of L2 Request (i.e.,… | column | dB Unsigned32 | .1.3.6.1.4.1.1795.2.24.2.6.24.1.1.1.11 |
| pdnAdslLineTransAtucConfig The transmission modes, represented by a bitmask, currently
enabled by the ATU-C. The manager can only set those modes
that are supported by the ATU-C. An ATU-C's supported mod… | column | PdnAdslTransmissionModeType | .1.3.6.1.4.1.1795.2.24.2.6.24.1.1.1.2 |
| pdnAdslLineTransAtucActual The actual transmission mode of the ATU-C. During ADSL line
initialization, the ADSL Transceiver Unit Remote terminal
end (ATU-R) will determine the mode used for the link. This… | column | PdnAdslTransmissionModeType | .1.3.6.1.4.1.1795.2.24.2.6.24.1.1.1.3 |
| pdnAdslLinePowerManagementConfig This object enables or disables power management functionality. | column | Enumeration | .1.3.6.1.4.1.1795.2.24.2.6.24.1.1.1.4 |
| pdnAdslLineSpectrumProfile The value of this object identifies the row in the ADSL
Line Spectrum Profile Table, pdnAdslLineSpectrumProfileTable,
which applies for this ADSL line. If this object is not
a zer… | column | OctetString | .1.3.6.1.4.1.1795.2.24.2.6.24.1.1.1.5 |
| pdnAdslLinePmMode The line states the ATU-C or ATU-R may autonomously transition
to on this line. It is coded in a bit-map representation
(0 if not allowed, 1 if allowed) as follows:
idleStateL… | column | Bits | .1.3.6.1.4.1.1795.2.24.2.6.24.1.1.1.6 |
| pdnAdslLineL0Time The minimum time, in seconds, between and Exit from the L2 state
and the next Entry into the L2 state. | column | seconds Unsigned32 | .1.3.6.1.4.1.1795.2.24.2.6.24.1.1.1.7 |
| pdnAdslLineL2Time The minimum time, in seconds, between an Entry into the L2 state
and the first Power Trim in the L2 state and between two con-
secutive Power Trims in the L2 State. | column | seconds Unsigned32 | .1.3.6.1.4.1.1795.2.24.2.6.24.1.1.1.8 |