hwTrunkIfCrcErrorSwitchEnable
HUAWEI-IF-EXT-MIB ·
.1.3.6.1.4.1.2011.5.25.41.1.3.3.1.34
Object
column
r/w
EnabledStatus
make trunk member port stop in use if the port have crc error exceed the config threshold, the trunk would be down if member port in use is low
Context
- MIB
- HUAWEI-IF-EXT-MIB
- OID
.1.3.6.1.4.1.2011.5.25.41.1.3.3.1.34- Type
- column
- Access
- readwrite
- Status
- current
- Parent
- hwTrunkIfEntry
- Table
- hwTrunkIfTable
- Siblings
- 35
Syntax
EnabledStatus
- Source
- EnabledStatus
- Base type
Enumeration
Values & Constraints
Type Values
1 | enabled |
2 | disabled |
Related Objects
Sibling Objects
| Object | Type | Syntax | OID |
|---|---|---|---|
| hwTrunkIndex The value of this object identifies the index of a trunk interface. The currently supported value ranges from 0 to 511. | column | SNMPv2-SMIInteger32 | .1.3.6.1.4.1.2011.5.25.41.1.3.3.1.1 |
| hwTrunkIfWorkingState Current working state of backup-access trunk.
1: general mode working state
2: initialization
3: master working
4: backup working | column | Enumeration | .1.3.6.1.4.1.2011.5.25.41.1.3.3.1.10 |
| hwTrunkIfAutoRecover If auto-recover has been set, the master port will be
working instead of the other port when it changes from
down state to up state.
1: don't support auto-recover
2: support auto… | column | Enumeration | .1.3.6.1.4.1.2011.5.25.41.1.3.3.1.11 |
| hwTrunkIfPreemptEnable This object indicates whether LACP priority preemption in static mode is enabled.
By default, this function is not enabled. | column | Enumeration | .1.3.6.1.4.1.2011.5.25.41.1.3.3.1.12 |
| hwTrunkIfPreemptDelay The value of this object identifies the delay for LACP priority preemption in static mode. You can set this object only after hwTrunkIfPreemptEnable is enabled. The value ranges f… | column | Integer32 | .1.3.6.1.4.1.2011.5.25.41.1.3.3.1.13 |
| hwTrunkIfTimeoutReceive The value of this object identifies the timeout period for receiving LACPDUs on an interface in static LACP mode. The value can be:
fast: specifies the timeout period for receivin… | column | Enumeration | .1.3.6.1.4.1.2011.5.25.41.1.3.3.1.14 |
| hwTrunkIfFlushSendEnable Whether or not permit the trunk to transmit FlushDUs.It is only used
when it is in the handwork 1:1 mode.Once it is enabled, the newly active
interface in the trunk will send Sm… | column | Enumeration | .1.3.6.1.4.1.2011.5.25.41.1.3.3.1.15 |
| hwTrunkIfFlushVlanId The ID of Vlan the partner port belongs to.When it is 0, it indicates
the function of sending FlushPDU is disabled. | column | Integer32 | .1.3.6.1.4.1.2011.5.25.41.1.3.3.1.16 |
| hwTrunkIfFlushPasswd A 16-octet read-create value used to define the password for negotiation. | column | SnmpPasswdString | .1.3.6.1.4.1.2011.5.25.41.1.3.3.1.17 |
| hwTrunkIfForceSwitchEnable It is only used when it is in the handwork 1:1 mode and the current
working link is the backup link. At that time, working link will move
from backup link to master link. Howeve… | column | Enumeration | .1.3.6.1.4.1.2011.5.25.41.1.3.3.1.18 |
| hwTrunkIfStatReset Reset the statistic information of LACPDUsRx,MarkerPDUsRx,LACPDUsTx,
MarkerResponsePDUsTx for all the ports in the current trunk. | column | Enumeration | .1.3.6.1.4.1.2011.5.25.41.1.3.3.1.19 |
| hwTrunkIfID The identification of the Trunk interface. It may identify Trunk
and is an index of the interface. | column | SNMPv2-SMIInteger32 | .1.3.6.1.4.1.2011.5.25.41.1.3.3.1.2 |
| hwTrunkBandwidth Current bandwidth of trunk in units of 1,000,000 bits per second. This bandwidth is the peculiar property of Eth-Trunk. And to the other kinds of trunk, this bandwidth is -1. | column | SNMPv2-SMIInteger32 | .1.3.6.1.4.1.2011.5.25.41.1.3.3.1.20 |
| hwTrunkIfArpSendSpeed Indicates the rate of sending gratuitous ARP packets (in pkts/sec) on the trunk member interface. | column | Integer32 | .1.3.6.1.4.1.2011.5.25.41.1.3.3.1.21 |
| hwTrunkIfLagSelectedPortStd This object indicates the port selection standard of LACP: based either on the port rate or on the port priority. By default, LACP selects ports based on the port priority.
speed(… | column | Enumeration | .1.3.6.1.4.1.2011.5.25.41.1.3.3.1.22 |
| hwTrunkIfLagMaxActiveLinkNum The value of this object identifies the upper threshold of interfaces that can be selected by the Eth-Trunk in static mode. | column | SNMPv2-SMIInteger32 | .1.3.6.1.4.1.2011.5.25.41.1.3.3.1.23 |
| hwTrunkETrunkPriority The priority of the E-Trunk. | column | Integer32 | .1.3.6.1.4.1.2011.5.25.41.1.3.3.1.24 |
| hwTrunkETrunkSysID The system ID of the E-Trunk. If set ffff-ffff-ffff the system ID will be to default. | column | SNMPv2-TCPhysAddress | .1.3.6.1.4.1.2011.5.25.41.1.3.3.1.25 |
| hwTrunkETrunkPriorityReset Status of operation, there are yes(1) and no(2).
It expresses whether the configure of E-Trunk priority is resetted. | column | Enumeration | .1.3.6.1.4.1.2011.5.25.41.1.3.3.1.26 |
| hwTrunkETrunkSysIDReset Status of operation, there are yes(1) and no(2).
It expresses whether the configure of E-Trunk system ID is resetted. | column | Enumeration | .1.3.6.1.4.1.2011.5.25.41.1.3.3.1.27 |
| hwTrunkLocalPrefMode Local-preference transmit mode of eth-trunk, there are enable(1) and disable(2).The default value is enable(1). | column | Enumeration | .1.3.6.1.4.1.2011.5.25.41.1.3.3.1.28 |
| hwTrunkIfTrackVrrpVrid The VRID which the static mode Eth-trunk tracked to. | column | SNMPv2-SMIInteger32 | .1.3.6.1.4.1.2011.5.25.41.1.3.3.1.29 |
| hwTrunkIfType The type of the Trunk interface includes eth-trunk and ip-trunk.
The ip-trunk is only comprised by pos link, otherwise the eth-trunk
is only comprised by ethernet link. | column | Enumeration | .1.3.6.1.4.1.2011.5.25.41.1.3.3.1.3 |
| hwTrunkIfTrackVrrpIfIndex The VRRP interface which the static mode Eth-trunk tracked to. | column | IF-MIBInterfaceIndex | .1.3.6.1.4.1.2011.5.25.41.1.3.3.1.30 |
| hwTrunkIfTrackVrrpReset Status of operation, there are yes(1) and no(2).
The value of this object identifies whether
the operation of clearing the configuration
is performed. And the configuration is t… | column | Enumeration | .1.3.6.1.4.1.2011.5.25.41.1.3.3.1.31 |
| hwTrunkIfBackupPreemptEnable The preemption according to the master and slave port will be and only be enabled when eth-trunk is working in backup mode.
In default condition, the preemption is disabled. | column | EnabledStatus | .1.3.6.1.4.1.2011.5.25.41.1.3.3.1.32 |
| hwTrunkIfBackupPreemptDelay The waiting time for priority preemption; Unit: minute.
It is enabled only when the priority preemption is enabled.
It indicates, When it comes to priority preemption, the operati… | column | Integer32 | .1.3.6.1.4.1.2011.5.25.41.1.3.3.1.33 |
| hwTrunkIfLagTimeOut The expired time(Unit is second) of the port to receive LACPDUS in the fast mode.
The hwTrunkIfTimeoutReceive is the type of timeout and use hwTrunkIfLagTimeOut to change time in … | column | Integer32 | .1.3.6.1.4.1.2011.5.25.41.1.3.3.1.35 |
| hwTrunkMemCount The count of Trunk member interfaces per Trunk. | column | SNMPv2-SMIInteger32 | .1.3.6.1.4.1.2011.5.25.41.1.3.3.1.36 |
| hwTrunkIfIndex Index number of the Trunk interface, it is consistent with ifIndex
of ifTable in IF-MIB. | column | IF-MIBInterfaceIndex | .1.3.6.1.4.1.2011.5.25.41.1.3.3.1.4 |
| hwTrunkIfModel Participated model of interface load. sourceDesMac(2) and
sourceMac(10) and desMac(11) are Layer2 hash arithmetic. | column | Enumeration | .1.3.6.1.4.1.2011.5.25.41.1.3.3.1.5 |
| hwTrunkIfBandWidthAffectLinkNum The value of this object identifies the maximum number of trunk interfaces that can be created.
By default, the maximum number of trunk interfaces that can be created is 32.
This … | column | SNMPv2-SMIInteger32 | .1.3.6.1.4.1.2011.5.25.41.1.3.3.1.6 |
| hwTrunkIfMinLinkNum The value of this object identifies the minimum number of trunk interfaces that can be created.
The currently supported value ranges from 1 to 32. By default, the minimum number o… | column | SNMPv2-SMIInteger32 | .1.3.6.1.4.1.2011.5.25.41.1.3.3.1.7 |
| hwTrunkIfRowStatus Current operation status of the row | column | SNMPv2-TCRowStatus | .1.3.6.1.4.1.2011.5.25.41.1.3.3.1.8 |
| hwTrunkIfWorkingMode The value of this object identifies the working mode of an Eth-Trunk interface.
1: master/backup access mode
2: normal mode
3: static LACP mode
4: compatible LACP mode
5: … | column | Enumeration | .1.3.6.1.4.1.2011.5.25.41.1.3.3.1.9 |