This trap is used to inform network management system that a delta 
fault event (events that are automatically cleared) has occured 
or a normal fault event (not automatically cleared) state has 
been set on.  
          
Objects are used as follows:
- eventSeqNum is the sequence number of the event. For normal 
type of events must equal to the sequence number of the event 
in the events table. 
- eventEventId specifies what fault event has occured.
- eventName specifies the name of the fault event.
- eventSetTime indicates when fault event has occured 
(delta events) or when fault has been set on (normal events).
- eventSeverity reports the severity level of the event.
- eventInstanceType indicates what kind of object is faulty.
- eventInstanceId specifies what instance is faulty.
- eventInstanceName may contain textual description for 
the faulty object.
- eventServAffective specifies whether the event is 
immediately service affcetive. 
- eventDescription reports possible additional information about the event. 
- trapPersistence tells whether this event is a delta or normal event. 
- trapSenderNodeId specifies the node ID of the sending network element if 
configuring it is supported for the network element, otherwise 0. 
- sysObjectID specifies what kind of equipment reports the fault event.
          
For more information see the eventTable specification

This trap is used to inform network management system that a normal 
type fault event has been cleared (state set off). 
          
Objects are used as follows:
- eventSeqNum is the sequence number of the this clearing event. Note that 
the sequence number of the cleared event is reported in the trapRefSeqNum 
object. 
- eventEventId specifies what event has been cleared.
- eventSetTime indicates when fault event has been cleared.
- eventInstanceType indicates what kind of object has been 
faulty.
- eventInstanceId specifies what instance has been faulty.
- trapRefSeqNum specifies the sequence number of the cleared event (i.e. 
the sequence number was assigned for the event in the events table).  
- trapSenderNodeId specifies the node ID of the sending network element if 
configuring it is supported for the network element, otherwise 0. 
- sysObjectID specifies what kind of equipment reports the clearing event.
          
For more information see the eventTable specification