A3COM-SWITCHING-SYSTEMS-TOKEN-RING-MIB Table View

The index of the token ring port identified by this entry,
relative to this agent.

The value of the MIB-II ifIndex corresponding to the
token ring port identified by this entry.

An ASCII text string describing the token ring port
identified by this entry.

The current value of the link status for the token ring port
identified by this entry.

Specific port type description for the token ring port
identified by this entry.

The current mode of the port. The default mode (station) is
used to connect a hub to the port. Lobe mode is used to direct
connect a Token Ring station into the port. This selection
can only be made on ports 1 and 2 o…

The current speed of the port. The default speed is
sixteenMegabit.

This counter is incremented when a frame
or token is copied or repeated by a
station, the E bit is zero in the frame
or token and one of the following
conditions exists: 1) there is a
non-data bit (J or K bit) between t…

This counter is incremented when a station
detects the absence of transitions for five
half-bit timers (burst-five error).

This counter is incremented when a station
receives an AMP or SMP frame in which A is
equal to C is equal to 0, and then receives
another SMP frame with A is equal to C is
equal to 0 without first receiving an AMP
frame…

This counter is incremented when a station
transmits an abort delimiter while
transmitting.

This counter is incremented when a station
recognizes an internal error.

This counter is incremented when a station
is transmitting and its TRR timer expires.
This condition denotes a condition where a
transmitting station in strip mode does not
receive the trailer of the frame before the
TR…

This counter is incremented when a station
recognizes a frame addressed to its
specific address, but has no available
buffer space indicating that the station
is congested.

This counter is incremented when a station
recognizes a frame addressed to its
specific address and detects that the FS
field A bits are set to 1 indicating a
possible line hit or duplicate address.

This counter is incremented when a station
acting as the active monitor recognizes an
error condition that needs a token
transmitted.

The number of Soft Errors the interface
has detected. It directly corresponds to
the number of Report Error MAC frames
that this interface has transmitted.
Soft Errors are those which are
recoverable by the MAC layer pr…

The number of times this interface has
detected an immediately recoverable
fatal error. It denotes the number of
times this interface is either
transmitting or receiving beacon MAC
frames.

The number of times this interface has
transmitted a beacon frame.

The number of times the interface has
detected an open or short circuit in the
lobe data path. The adapter will be closed
when this condition occurs.

The number of times the interface has
received a Remove Ring Station MAC frame
request. When this frame is received
the interface will enter the close state.

The number of times the interface has
sensed that it is the only station on the
ring. This will happen if the interface
is the first one up on a ring, or if
there is a hardware problem.

The number of times the interface has
detected that the frequency of the
incoming signal differs from the expected
frequency.

The current interface status which can
be used to diagnose fluctuating problems
that can occur on token rings, after a
station has successfully been added to
the ring.
Before an open is completed, this
object has the va…