a3ComSysTokenRingPortRingStatus

A3COM-SWITCHING-SYSTEMS-TOKEN-RING-MIB · .1.3.6.1.4.1.43.29.4.13.2.1.24
MIB view Table view

Object

column mandatory Integer32 
The current interface status which can
be used to diagnose fluctuating problems
that can occur on token rings, after a
station has successfully been added to
the ring.
Before an open is completed, this
object has the value for the 'no status'
condition.  This object is useful for
debugging problems when the station
can not even enter the ring.
The object's value is a sum of
values, one for each currently applicable
condition.  The following values are
defined for various conditions:
0 = No Problems detected
32 = Ring Recovery
64 = Single Station
256 = Remove Received
512 = reserved
1024 = Auto-Removal Error
2048 = Lobe Wire Fault
4096 = Transmit Beacon
8192 = Soft Error
16384 = Hard Error
32768 = Signal Loss
131072 = no status, open not completed.

Context

MIB
A3COM-SWITCHING-SYSTEMS-TOKEN-RING-MIB
OID
.1.3.6.1.4.1.43.29.4.13.2.1.24
Type
column
Access
readonly
Status
mandatory
Parent
a3ComSysTokenRingPortEntry
Table
a3ComSysTokenRingPortTable
Siblings
23

Syntax

Integer32
Source
COPS-PR-SPPIInteger32
Base type
Integer32

Values & Constraints

Type Constraints
range: -2147483648..2147483647

Related Objects

Sibling Objects
ObjectTypeSyntaxOID
a3ComSysTokenRingPortIndex mandatory
The index of the token ring port identified by this entry, relative to this agent.
columnInteger32.1.3.6.1.4.1.43.29.4.13.2.1.1
a3ComSysTokenRingPortACErrors mandatory
This counter is incremented when a station receives an AMP or SMP frame in which A is equal to C is equal to 0, and then receives another SMP frame with A is equal to C is equal t…
columnRFC1155-SMICounter.1.3.6.1.4.1.43.29.4.13.2.1.10
a3ComSysTokenRingPortAbortTransErrors mandatory
This counter is incremented when a station transmits an abort delimiter while transmitting.
columnRFC1155-SMICounter.1.3.6.1.4.1.43.29.4.13.2.1.11
a3ComSysTokenRingPortInternalErrors mandatory
This counter is incremented when a station recognizes an internal error.
columnRFC1155-SMICounter.1.3.6.1.4.1.43.29.4.13.2.1.12
a3ComSysTokenRingPortLostFrameErrors mandatory
This counter is incremented when a station is transmitting and its TRR timer expires. This condition denotes a condition where a transmitting station in strip mode does not receiv…
columnRFC1155-SMICounter.1.3.6.1.4.1.43.29.4.13.2.1.13
a3ComSysTokenRingPortReceiveCongestionErrors mandatory
This counter is incremented when a station recognizes a frame addressed to its specific address, but has no available buffer space indicating that the station is congested.
columnRFC1155-SMICounter.1.3.6.1.4.1.43.29.4.13.2.1.14
a3ComSysTokenRingPortFrameCopiedErrors mandatory
This counter is incremented when a station recognizes a frame addressed to its specific address and detects that the FS field A bits are set to 1 indicating a possible line hit or…
columnRFC1155-SMICounter.1.3.6.1.4.1.43.29.4.13.2.1.15
a3ComSysTokenRingPortTokenErrors mandatory
This counter is incremented when a station acting as the active monitor recognizes an error condition that needs a token transmitted.
columnRFC1155-SMICounter.1.3.6.1.4.1.43.29.4.13.2.1.16
a3ComSysTokenRingPortSoftErrors mandatory
The number of Soft Errors the interface has detected. It directly corresponds to the number of Report Error MAC frames that this interface has transmitted. Soft Errors are those w…
columnRFC1155-SMICounter.1.3.6.1.4.1.43.29.4.13.2.1.17
a3ComSysTokenRingPortHardErrors mandatory
The number of times this interface has detected an immediately recoverable fatal error. It denotes the number of times this interface is either transmitting or receiving beacon M…
columnRFC1155-SMICounter.1.3.6.1.4.1.43.29.4.13.2.1.18
a3ComSysTokenRingPortTransmitBeacons mandatory
The number of times this interface has transmitted a beacon frame.
columnRFC1155-SMICounter.1.3.6.1.4.1.43.29.4.13.2.1.19
a3ComSysTokenRingPortIfIndex mandatory
The value of the MIB-II ifIndex corresponding to the token ring port identified by this entry.
columnInteger32.1.3.6.1.4.1.43.29.4.13.2.1.2
a3ComSysTokenRingPortLobeWires mandatory
The number of times the interface has detected an open or short circuit in the lobe data path. The adapter will be closed when this condition occurs.
columnRFC1155-SMICounter.1.3.6.1.4.1.43.29.4.13.2.1.20
a3ComSysTokenRingPortRemoves mandatory
The number of times the interface has received a Remove Ring Station MAC frame request. When this frame is received the interface will enter the close state.
columnRFC1155-SMICounter.1.3.6.1.4.1.43.29.4.13.2.1.21
a3ComSysTokenRingPortSingles mandatory
The number of times the interface has sensed that it is the only station on the ring. This will happen if the interface is the first one up on a ring, or if there is a hardware p…
columnRFC1155-SMICounter.1.3.6.1.4.1.43.29.4.13.2.1.22
a3ComSysTokenRingPortFreqErrors mandatory
The number of times the interface has detected that the frequency of the incoming signal differs from the expected frequency.
columnRFC1155-SMICounter.1.3.6.1.4.1.43.29.4.13.2.1.23
a3ComSysTokenRingPortLabel mandatory
An ASCII text string describing the token ring port identified by this entry.
columnOctetString.1.3.6.1.4.1.43.29.4.13.2.1.3
a3ComSysTokenRingPortInsertStatus mandatory
The current value of the link status for the token ring port identified by this entry.
columnEnumeration.1.3.6.1.4.1.43.29.4.13.2.1.4
a3ComSysTokenRingPortType mandatory
Specific port type description for the token ring port identified by this entry.
columnEnumeration.1.3.6.1.4.1.43.29.4.13.2.1.5
a3ComSysTokenRingPortMode mandatory
The current mode of the port. The default mode (station) is used to connect a hub to the port. Lobe mode is used to direct connect a Token Ring station into the port. This selec…
columnEnumeration.1.3.6.1.4.1.43.29.4.13.2.1.6
a3ComSysTokenRingPortSpeed mandatory
The current speed of the port. The default speed is sixteenMegabit.
columnEnumeration.1.3.6.1.4.1.43.29.4.13.2.1.7
a3ComSysTokenRingPortLineErrors mandatory
This counter is incremented when a frame or token is copied or repeated by a station, the E bit is zero in the frame or token and one of the following conditions exists: 1) there …
columnRFC1155-SMICounter.1.3.6.1.4.1.43.29.4.13.2.1.8
a3ComSysTokenRingPortBurstErrors mandatory
This counter is incremented when a station detects the absence of transitions for five half-bit timers (burst-five error).
columnRFC1155-SMICounter.1.3.6.1.4.1.43.29.4.13.2.1.9