zxAnXdsl2LnCmndConfBpsc

Command:Request a bits per sub-carrier measurement to be made.
              
A request for a bits per sub-carrier measurement is made
by setting this attribute to the value of measure(2).
Upon completion of the measurement request,
the Access Node shall set this attribute to idle(1).
              
Note that a bits per sub-carrier measurement is also
performed during a line diagnostic procedure. This
attribute provides an additional mechanism to fetch
the bits per sub-carrier data. This additional
mechanism is provided so that bits per sub-carrier
data may be fetched without forcing the line into no
power state. This is useful because the bits per
sub-carrier allocation may be adjusted at show time
due to rate adaption and bit swapping.
              
The implementation of this additional mechanism for
measuring bits per sub-carrier is not mandatory.
              
The results of the bits per sub-carrier measurement are
stored in xdsl2LineSegmentTable. The status of the bits
per sub-carrier measurement is indicated by
xdsl2LineCmndConfBpscFailReason.

MIB

ZTE-AN-XDSL2-MIBII

OID

.1.3.6.1.4.1.3902.1015.1001.1.2.10.1.23

Type

column

Access

readwrite

Status

current

Parent

zxAnXdsl2LnEntry