wtnStandbyTransmitFrequency

Standby Transmit frequency as described in zhoneRadio-TC.mib.
              
              
23Ghz family:  ( according to sysObjId )
-------------------------------------------   
If auto-switching is enabled, the
frequency shown will be used in the event the currently active
frequency fails due to low RSSI, or high BER.  Note the switch
will occur only if wtnAutoChannelSwitchEnable is true(1).
              
The transmit frequency is entered as a floating point number in Mhz,
for example, 23565.5 for 23.5655Ghz.
              
If the frequency entered or the calulated receive frequency
outside the range of the unit, an error will be returned and the
value left unchanged.
              
If the link is operational, the new standby frequencies will be changed
at the opposite end before the values at the local end are changed.
              
              
5.7Ghz family: (according to sysObjId )
-----------------------------------------
Value will reflect the frequency of the currently
active channel (wtnStandbyChannelNumber).
Writing to this variable will have no effect.

MIB

ZHONE-PHY-WTN-RADIO-MIB

OID

.1.3.6.1.4.1.5504.5.8.1.1.5

Type

column

Access

readwrite

Status

current

Units

Hz

Parent

wtnConfigEntry