dataIfT38BasePort

MX-DATAIF-MIB · .1.3.6.1.4.1.4935.15.35.1.15
MIB view Table view

Object

scalar r/w Unsigned32 
T.38 base port.
          
The T.38 ports are allocated starting from this base port.
The units use as many T.38 ports as the number of FXS/FXO interfaces.
          
E.g.: let's say for instance that a unit has two FXS interfaces and
the base port is defined on 6004:
   - if there is currently no ongoing call and FXS connector 1 has an
     incoming or outgoing call, it will use the T.38 port 6004.
          
   - if there is currently a call on FXS connector 1 and FXS connector 2
     has an incoming or outgoing call, then FXS connector 2 will use the
     T.38 port 6005.

Context

MIB
MX-DATAIF-MIB
OID
.1.3.6.1.4.1.4935.15.35.1.15
Type
scalar
Access
readwrite
Status
current
Parent
dataIfMIBObjects
Siblings
5

Syntax

Unsigned32

Values & Constraints

Object Constraints
range: 1025-64535

Related Objects

Sibling Objects
ObjectTypeSyntaxOID
dataIfT38NoSignalTimeout
The period, in seconds, at which no-signal packets are sent during a T.38 transmission, in the absence of valid data.
scalarUnsigned32.1.3.6.1.4.1.4935.15.35.1.140
dataIfTable
Data interface configuration table.
table-.1.3.6.1.4.1.4935.15.35.1.18
dataIfCodecTable
Table that contains data interface configuration parameters.
table-.1.3.6.1.4.1.4935.15.35.1.20
dataIfT38FinalFramesRedundancy
Defines the number of times T.38 packets will be retransmitted. This only applies to the T.38 packets where the PrimaryUDPTL contains the following T.38 data type: HDLC_SIG_END,…
scalarUnsigned32.1.3.6.1.4.1.4935.15.35.1.40
dataIfT38NoSignalEnable
Enable/disable the sending of T.38 no-signal packets. When enabled, the unit will ensure that, during a T.38 fax transmission, data is sent out at least every time the dataIfT38No…
scalarMX-TCMxEnableState.1.3.6.1.4.1.4935.15.35.1.90