mplsLdpEntityFrameRelayLRRowStatus

MPLS-LDP-FRAME-RELAY-STD-MIB · .1.3.6.1.2.1.10.166.6.1.1.2.1.5

Object

column r/w SNMPv2-TCRowStatus

The status of this conceptual row.  All writable
objects in this row may be modified at any time,
however, as described in detail in the section
entitled, 'Changing Values After Session
Establishment', and again described in the
DESCRIPTION clause of the
mplsLdpEntityAdminStatus object,
if a session has been initiated with a Peer,
changing objects in this table will
wreak havoc with the session and interrupt
traffic.  To repeat again:
the recommended procedure is to set the
mplsLdpEntityAdminStatus to down, thereby
explicitly causing a session to be torn down. Then,
change objects in this entry, then set the
mplsLdpEntityAdminStatus to enable which enables
a new session to be initiated.

Context

MIB: MPLS-LDP-FRAME-RELAY-STD-MIB
OID: .1.3.6.1.2.1.10.166.6.1.1.2.1.5
Type: column
Access: readwrite
Status: current
Parent: mplsLdpEntityFrameRelayLREntry
Table: mplsLdpEntityFrameRelayLRTable
Siblings: 4

Syntax

SNMPv2-TCRowStatus

Source: SNMPv2-TCRowStatus
Base type: Enumeration

Values & Constraints

Type Values

`1`	active
`2`	notInService
`3`	notReady
`4`	createAndGo
`5`	createAndWait
`6`	destroy

Related Objects

Sibling Objects

Object	Type	Syntax	OID
mplsLdpEntityFrameRelayLRMinDlci The lower bound which is supported. This value should be the same as that in the Frame Relay Label Range Component's Minimum DLCI field. The value of zero is valid for the minim…	column	FRAME-RELAY-DTE-MIBDLCI	`.1.3.6.1.2.1.10.166.6.1.1.2.1.1`
mplsLdpEntityFrameRelayLRMaxDlci The upper bound which is supported. This value should be the same as that in the Frame Relay Label Range Component's Maximum DLCI field.	column	FRAME-RELAY-DTE-MIBDLCI	`.1.3.6.1.2.1.10.166.6.1.1.2.1.2`
mplsLdpEntityFrameRelayLRLen This object specifies the length of the DLCI bits. This is the EXACT value for the Len field of the Frame Relay Label Range Component. The descriptio…	column	Enumeration	`.1.3.6.1.2.1.10.166.6.1.1.2.1.3`
mplsLdpEntityFrameRelayLRStorageType The storage type for this conceptual row. Conceptual rows having the value 'permanent(4)' need not allow write-access to any columnar objects in the row.	column	SNMPv2-TCStorageType	`.1.3.6.1.2.1.10.166.6.1.1.2.1.4`