psrMplsLinearProtWpathSupvType
LUM-PSR-MIB ·
.1.3.6.1.4.1.8708.2.43.2.2.1.1.12
Object
column
SupvType
Supervision type of the working/protection path in protection domain.
layer1(1) -- the path state depends only on layer1 faults
on the local port.
bfd (2) -- the path is monitored by BFD session.
Context
- MIB
- LUM-PSR-MIB
- OID
.1.3.6.1.4.1.8708.2.43.2.2.1.1.12- Type
- column
- Access
- readonly
- Status
- current
- Parent
- psrMplsLinearProtEntry
- Table
- psrMplsLinearProtTable
- Siblings
- 22
Syntax
SupvType
- Source
- SupvType
- Base type
Enumeration
Values & Constraints
Type Values
1 | layer1 |
2 | bfd |
Related Objects
Sibling Objects
| Object | Type | Syntax | OID |
|---|---|---|---|
| psrMplsLinearProtIndex An arbitrary index assigned to each entry. | column | Unsigned32 | .1.3.6.1.4.1.8708.2.43.2.2.1.1.1 |
| psrMplsLinearProtWorkingPathIndex The index of the working path. | column | Unsigned32 | .1.3.6.1.4.1.8708.2.43.2.2.1.1.10 |
| psrMplsLinearProtWorkingPathState The status of the working path.
down (1) -- signal fail condition is reported
up (2) -- no abnormal condition
unknown (3) -- no board present | column | PathState | .1.3.6.1.4.1.8708.2.43.2.2.1.1.11 |
| psrMplsLinearProtProtectionPathId Identifier of the protection path. | column | SNMPv2-TCDisplayString | .1.3.6.1.4.1.8708.2.43.2.2.1.1.13 |
| psrMplsLinearProtProtectionPathIndex The index of the protection path. | column | Unsigned32 | .1.3.6.1.4.1.8708.2.43.2.2.1.1.14 |
| psrMplsLinearProtProtectionPathState The state of the protection path.
down (1) -- signal fail condition is reported
up (2) -- no abnormal condition
unknown (3) -- no board present | column | PathState | .1.3.6.1.4.1.8708.2.43.2.2.1.1.15 |
| psrMplsLinearProtPpathSupvType Supervision type of the working/protection path in protection domain.
layer1(1) -- the path state depends only on layer1 faults
on the local port.
bfd (2) -- the pa… | column | SupvType | .1.3.6.1.4.1.8708.2.43.2.2.1.1.16 |
| psrMplsLinearProtActivePath Indicates which path is transporting the traffic.
workingPath (1)
-- the data traffic is transported on working path
protectionPath (2)
-- the data traffic is transported … | column | Enumeration | .1.3.6.1.4.1.8708.2.43.2.2.1.1.17 |
| psrMplsLinearProtOperatorCommand The operator command.
Operator command may not be executed because an equal or higher priority
local/remote event is in effect.
noRequest (1)
-- cancel an active local administ… | column | Enumeration | .1.3.6.1.4.1.8708.2.43.2.2.1.1.18 |
| psrMplsLinearProtHoldoffTimer Hold-off timer coordinates timing of protection
switches. When a signal fail event occurs, this event
should not be reported before the hold-off timer
has elapsed.
Unit: milliseco… | column | Unsigned32 | .1.3.6.1.4.1.8708.2.43.2.2.1.1.19 |
| psrMplsLinearProtInternalReference For internal use only. | column | Unsigned32 | .1.3.6.1.4.1.8708.2.43.2.2.1.1.2 |
| psrMplsLinearProtProtectionFailed Failure detected on all available paths in tunnel. | column | LUM-TCFaultStatus | .1.3.6.1.4.1.8708.2.43.2.2.1.1.20 |
| psrMplsLinearProtProtectionDegraded Failure detected on working path or protection path, or traffic is locked
to one path. | column | LUM-TCFaultStatus | .1.3.6.1.4.1.8708.2.43.2.2.1.1.21 |
| psrMplsLinearProtCommunicationFailure No connection with far-end LER. | column | LUM-TCFaultStatus | .1.3.6.1.4.1.8708.2.43.2.2.1.1.22 |
| psrMplsLinearProtConfigMismatch Configuration of protection mode mismatch between local and far-end LER. | column | LUM-TCFaultStatus | .1.3.6.1.4.1.8708.2.43.2.2.1.1.23 |
| psrMplsLinearProtName The management name of the interface, for example
'linPrt:1:2:tunnelId', where the first number indicates
subrack, the second slot number, and the third is
the tunnel Id, to which… | column | LUM-TCMgmtNameString | .1.3.6.1.4.1.8708.2.43.2.2.1.1.3 |
| psrMplsLinearProtTunnelId The tunnel that this protection is applied to. | column | SNMPv2-TCDisplayString | .1.3.6.1.4.1.8708.2.43.2.2.1.1.4 |
| psrMplsLinearProtAdminStatus The administrative state for the object.
down - The object is de-activated.
up - The object will be activated when
available. | column | Enumeration | .1.3.6.1.4.1.8708.2.43.2.2.1.1.5 |
| psrMplsLinearProtState The state of the protection domain.
normal (1)
-- both the protection and working paths are fully allocated
and active
protectionPathUnavailabe (2)
-… | column | Enumeration | .1.3.6.1.4.1.8708.2.43.2.2.1.1.6 |
| psrMplsLinearProtLocalEvent The input request that is triggered locally.
unknown (1)
-- no board present
noRequest (2)
-- none of the input sources have generated any input locally
lockOut (3)
--… | column | InputRequest | .1.3.6.1.4.1.8708.2.43.2.2.1.1.7 |
| psrMplsLinearProtRemoteEvent The last received remote request.
unknown (1)
-- no board present
noRequest (2)
-- the remote end point has no abnormal condition to report
lockOut (3)
-- the remote e… | column | InputRequest | .1.3.6.1.4.1.8708.2.43.2.2.1.1.8 |
| psrMplsLinearProtWorkingPathId Identifier of the working path. | column | SNMPv2-TCDisplayString | .1.3.6.1.4.1.8708.2.43.2.2.1.1.9 |