mplsOutSegmentIfIndex

HP-SN-MPLS-LSR-MIB · .1.3.6.1.4.1.11.2.3.7.11.12.2.15.15.2.1.6.1.2
Commands MIB view Table view

Object

column r/w IF-MIBInterfaceIndexOrZero 
This value must contain the interface index of the
outgoing interface. This object may only take the
value of 0 during the create-and-wait row creation
operation if the management station has not yet set
the value of this object. This object cannot be
modified if mplsOutSegmentRowStatus is active(1).
The mplsOutSegmentRowStatus cannot be set to
active(1) until this object is set to a value
corresponding to a valid ifEntry.

Context

MIB
HP-SN-MPLS-LSR-MIB
OID
.1.3.6.1.4.1.11.2.3.7.11.12.2.15.15.2.1.6.1.2
Type
column
Access
readwrite
Status
current
Parent
mplsOutSegmentEntry
Groups
1

Net-SNMP examples

How SNMP and these commands work

Walk the column to discover its indexed instances, or supply every index to read one instance.

Walk the column
/usr/bin/snmpbulkwalk -v2c -c '<community>' -Pud -Ir -OQUs -m 'HP-SN-MPLS-LSR-MIB' -M '/opt/observium/mibs/hp:/opt/observium/mibs/rfc:/opt/observium/mibs/net-snmp' 'udp:<hostname>:161' 'HP-SN-MPLS-LSR-MIB::mplsOutSegmentIfIndex'
More examples
Read one indexed instance
/usr/bin/snmpget -v2c -c '<community>' -Pud -Ir -OQUv -m 'HP-SN-MPLS-LSR-MIB' -M '/opt/observium/mibs/hp:/opt/observium/mibs/rfc:/opt/observium/mibs/net-snmp' 'udp:<hostname>:161' 'HP-SN-MPLS-LSR-MIB::mplsOutSegmentIfIndex.<mplsOutSegmentIndex>'
Translate to a numeric OID
/usr/bin/snmptranslate -Pud -Ir -On -m 'HP-SN-MPLS-LSR-MIB' -M '/opt/observium/mibs/hp:/opt/observium/mibs/rfc:/opt/observium/mibs/net-snmp' 'HP-SN-MPLS-LSR-MIB::mplsOutSegmentIfIndex'

Syntax

IF-MIBInterfaceIndexOrZero
Source
IF-MIBInterfaceIndexOrZero
Base type
Integer32
Display format
d
Type Description
This textual convention is an extension of the
InterfaceIndex convention.  The latter defines a greater
than zero value used to identify an interface or interface
sub-layer in the managed system.  This extension permits the
additional value of zero.  the value zero is object-specific
and must therefore be defined as part of the description of
any object which uses this syntax.  Examples of the usage of
zero might include situations where interface was unknown,
or when none or all interfaces need to be referenced.

Values & Constraints

Type Constraints
range: 0..2147483647

Conformance

Member of
mplsOutSegmentGroup
Compliance refinements
mplsLsrModuleCompliance readonly
Write access is not required.