chanTestType

The chanTestType starts testing the continuity 
or delay of a connection.
It sends specific cell patterns toward the network 
and the terminating end of this connection has to be an
MGX8220 or ASI of a BPX in order for this test to be working. 
              
The receiving node would loop back when it receives these
cells. The test should be done in about couple of seconds.
The testcon tests the continuity of the connection and 
testdelay uses the same test except that it measures for 
delay through the network. 
To test the delay follow this procedure:
	a- set chanTestType to testdelay
	b- read chanTestState till it is Pass or Fail 
	c- Read chanRTDResult for the delay if it is Pass
	*Note that the chanTestType would go back to notest when the
	 test is completed 
To test the continuity follow this procedure:
	a- set chanTestType to testcon
	b- read chanTestState till it is Pass or Fail 
	*Note that the chanTestType would go back to notest when the
	 test is completed 
You CAN NOT select 2 tests back to back,
you have to select one and wait for
the result and then start the other one.
SYNTAX  
When you select testdelay 
              
This is the type of the test
1 = Test Continuity
2 = Test Delay
3 = No Test

MIB

CISCO-WAN-FR-CONN-MIB

OID

.1.3.6.1.4.1.351.110.5.1.2.1.1.1.22

Type

column

Access

readwrite

Status

current

Parent

frChanCnfGrpEntry