pagpOperGroupCapability
CISCO-PAGP-MIB ·
.1.3.6.1.4.1.9.9.98.1.1.1.1.4
Object
column
PagpGroupCapability
This variable informs the system administrator examining the
Fast
Etherchannel MIB of the capabilities of the current state of the
interface's hardware to form agports.
The pagpOperGroupCapability values are adjusted automatically by
the managed system to reflect configuration changes, such as
port
speed or duplex mode, which can affect the ability of an
interface
to join agports.
pagpOperGroupCapability reflects the ability to form
aggregations; it does not specify whether the interface is
or is not currently a member of such an aggregation.
pagpOperGroupCapability values are chosen so that no two
interfaces
may be aggregated unless both pagpPhysGroupCapability and
pagpAdminGroupCapability permit the aggregation, as well as the
current configuration of the interfaces.
pagpOperGroupCapability
may change dynamically, as a result of the operation of
automatic
configuration protocols such as PAgP, in order to prevent
illegal
aggregations.
When the PAgP protocol is enabled, then pagpOperGroupCapability
is the value of the group capability being transmitted on this
interface in PAgP packets.
Context
- MIB
- CISCO-PAGP-MIB
- OID
.1.3.6.1.4.1.9.9.98.1.1.1.1.4- Type
- column
- Access
- readonly
- Status
- current
- Parent
- pagpEtherChannelEntry
- Table
- pagpEtherChannelTable
- Siblings
- 11
Syntax
PagpGroupCapability
- Source
- PagpGroupCapability
- Base type
Integer32
Values & Constraints
No enumerated values or constraints recorded.
Related Objects
Sibling Objects
| Object | Type | Syntax | OID |
|---|---|---|---|
| pagpEthcOperationMode The managed device will refuse a request to set
pagpEthcOperationMode to the pagpOn(3) state if the device does
not implement the PAgP protocol. The managed device will refuse
to… | column | PagpEthcOperationMode | .1.3.6.1.4.1.9.9.98.1.1.1.1.1 |
| pagpDistributionAddress pagpDistributionAddress controls the type of distribution
on the configured pagpDistributionProtocol used on this
interface's agport to distribute outgoing data frames among its
… | column | Enumeration | .1.3.6.1.4.1.9.9.98.1.1.1.1.10 |
| pagpRate Specifies the rate at which the PAgP packets are transmitted
on this interface.
fast(1) : PAgP packets are transmitted at the fast rate
on this interface.
norm… | column | Enumeration | .1.3.6.1.4.1.9.9.98.1.1.1.1.11 |
| pagpInPacketTimeout Specifies the earliest time at which received PAgP
information packets are timed out. | column | Seconds Unsigned32 | .1.3.6.1.4.1.9.9.98.1.1.1.1.12 |
| pagpDeviceId Uniquely identifies a device which implements Fast
Etherchannel.
The combination of pagpDeviceId and ifIndex must be unique over
all interfaces in a network. pagpDeviceId typical… | column | SNMPv2-TCMacAddress | .1.3.6.1.4.1.9.9.98.1.1.1.1.2 |
| pagpPhysGroupCapability The values in pagpPhysGroupCapability indicate the aggregation
capability of the underlying hardware.
The speed, configuration, and status condition of the interfac… | column | PagpGroupCapability | .1.3.6.1.4.1.9.9.98.1.1.1.1.3 |
| pagpAdminGroupCapability pagpAdminGroupCapability is used by the network administrator
to
control the aggregation of interfaces into agports. The default
value of pagpAdminGroupCapability is equal to the… | column | PagpGroupCapability | .1.3.6.1.4.1.9.9.98.1.1.1.1.5 |
| pagpPortPriority The priority of this interface relative to other interfaces
when determining which interface is to be used in Hot
Standby mode.
Among all interfaces aggregated toge… | column | PagpPortPriority | .1.3.6.1.4.1.9.9.98.1.1.1.1.6 |
| pagpLearnMethod This interface's learning method value. Specifies whether this
device is able to learn the location of a source MAC address
based
on the agport on which it was received, agPort(2… | column | PagpLearnMethod | .1.3.6.1.4.1.9.9.98.1.1.1.1.7 |
| pagpGroupIfIndex If pagpGroupIfIndex is 0, then the inteface is not aggregated
to an agport, and is unavailable for normal data reception and
transmission.
If pagpGroupIfIndex equal… | column | CISCO-TCInterfaceIndexOrZero | .1.3.6.1.4.1.9.9.98.1.1.1.1.8 |
| pagpDistributionProtocol pagpDistributionProtocol controls the load balancing
algorithms used on this interface's agport to distribute
outgoing data frames among its component interfaces, such
as IP addr… | column | Enumeration | .1.3.6.1.4.1.9.9.98.1.1.1.1.9 |