clrPeerBackupInterface

CISCO-L4L7MODULE-REDUNDANCY-MIB · .1.3.6.1.4.1.9.9.650.1.1.1.1.3
Commands MIB view Table view

Object

column r/w IF-MIBInterfaceIndexOrZero 
This object specifies the backup interface used by the
peer. The backup interface is used in case the heart beat 
message is not received. This interface is used to 
send the heart beat message. If the message sent is not
successful, then it is assumed peer is down and switchover
will be initiated. If the message sent is successful 
on this interface, the peer transitions to standbyCold
and continue to monitor peer.

Context

MIB
CISCO-L4L7MODULE-REDUNDANCY-MIB
OID
.1.3.6.1.4.1.9.9.650.1.1.1.1.3
Type
column
Access
readwrite
Status
current
Parent
clrPeerConfigEntry
Groups
1

Net-SNMP examples

How SNMP and these commands work

Walk the column to discover its indexed instances, or supply every index to read one instance.

Walk the column
/usr/bin/snmpbulkwalk -v2c -c '<community>' -Pud -Ir -OQUs -m 'CISCO-L4L7MODULE-REDUNDANCY-MIB' -M '/opt/observium/mibs/cisco:/opt/observium/mibs/rfc:/opt/observium/mibs/net-snmp' 'udp:<hostname>:161' 'CISCO-L4L7MODULE-REDUNDANCY-MIB::clrPeerBackupInterface'
More examples
Read one indexed instance
/usr/bin/snmpget -v2c -c '<community>' -Pud -Ir -OQUv -m 'CISCO-L4L7MODULE-REDUNDANCY-MIB' -M '/opt/observium/mibs/cisco:/opt/observium/mibs/rfc:/opt/observium/mibs/net-snmp' 'udp:<hostname>:161' 'CISCO-L4L7MODULE-REDUNDANCY-MIB::clrPeerBackupInterface.<entPhysicalIndex>.<clrPeerId>'
Translate to a numeric OID
/usr/bin/snmptranslate -Pud -Ir -On -m 'CISCO-L4L7MODULE-REDUNDANCY-MIB' -M '/opt/observium/mibs/cisco:/opt/observium/mibs/rfc:/opt/observium/mibs/net-snmp' 'CISCO-L4L7MODULE-REDUNDANCY-MIB::clrPeerBackupInterface'

Syntax

IF-MIBInterfaceIndexOrZero
Source
IF-MIBInterfaceIndexOrZero
Base type
Integer32
Display format
d
Type Description
This textual convention is an extension of the
InterfaceIndex convention.  The latter defines a greater
than zero value used to identify an interface or interface
sub-layer in the managed system.  This extension permits the
additional value of zero.  the value zero is object-specific
and must therefore be defined as part of the description of
any object which uses this syntax.  Examples of the usage of
zero might include situations where interface was unknown,
or when none or all interfaces need to be referenced.

Values & Constraints

Type Constraints
range: 0..2147483647

Conformance

Member of
clrPeerConfigGroup