cfcGenericScaConfig

Gives the current configuration of the SCA ASIC.
              
quarterBandwidth (0)       -- 1/4th of the full bandwidth
                              is supported per slot by 
                              the switch.
halfBandwidth (1)          -- 1/2th of the full bandwidth
                              is supported per slot by 
                              the switch.
fullBandwidth (2)          -- Full bandwidth is supported
                              per slot by the switch.
enableParity (3)           -- Parity handling by SCA is 
                              enabled.
priMcast (4)               -- Priority of Multicast 
                              requests is greater then 
                              Unicast requests.
priUnicast (5)             -- Priority of Unicast 
                              requests is greater then 
                              Multicast requests.
priAlternating (6)         -- Alternate the priority 
                              between pri-mcast and 
                              pri-unicast modes every 
                              cell clock.
earlyIntrOnLOS (7)         -- Cause early interrupt on 
                              loss-of-sync error.
noEarlyIntrOnLOS (8)       -- Allow time to resync on 
                              loss-of-sync error.
forceXbarParityXer (9)     -- Force bad parity on xbar 
                              on every cell clock.
forceGrantParityXer (10)   -- Force bad partity on grant
                              to every line card.
unicastAcceptMode (11)     -- Enable unicast accept 
                              pointer updating only on 
                              cell periods when Unicast 
                              has higher priority over 
                              multicast.
forceXbarCrcOnCtlLink0 (12)-- Force CRC error on Xbar 
                              control link 0.
forceXbarCrcOnCtlLink0 (13)-- Force CRC error on Xbar 
                              control link 1.
forceXbarCrcOnCtlLink0 (14)-- Force CRC error on Xbar 
                              control link 2.
forceXbarCrcOnCtlLink0 (15)-- Force CRC error on Xbar 
                              control link 3.

MIB

CISCO-FABRIC-C12K-MIB

OID

.1.3.6.1.4.1.9.9.281.1.1.3.1.1.4

Type

column

Access

readonly

Status

current

Parent

cfcGenericScaEntry