cncNcdpHoldTime

CISCO-ATM-NETWORK-CLOCK-MIB · .1.3.6.1.4.1.9.9.121.1.1.6
Commands MIB view Table view

Object

scalar r/w millisecondsInteger32 
The delay between the transmission of NCDP configuration
PDUs.
          
The hold time is used to limit the transmission of NCDP 
configuration PDUs out of an interface to a maximum of one
configuration PDU per hold time interval per interface.
          
The value of this object should normally be set        to match the 
value of cncNcdpMessageInterval.  If the value of this 
object is higher than the value of cncNcdpMessageInterval,
NCDP configuration PDUs will end up being propagated at
the rate specified by the value of this object instead.
          
This object is only used by the NCDP protocol entity.

Context

MIB
CISCO-ATM-NETWORK-CLOCK-MIB
OID
.1.3.6.1.4.1.9.9.121.1.1.6
Type
scalar
Access
readwrite
Status
current
Units
milliseconds
Parent
cncGlobal
Groups
1

Net-SNMP examples

How SNMP and these commands work

Scalars have one instance, identified by the .0 suffix.

Read the scalar instance
/usr/bin/snmpget -v2c -c '<community>' -Pud -Ir -OQUv -m 'CISCO-ATM-NETWORK-CLOCK-MIB' -M '/opt/observium/mibs/cisco:/opt/observium/mibs/rfc:/opt/observium/mibs/net-snmp' 'udp:<hostname>:161' 'CISCO-ATM-NETWORK-CLOCK-MIB::cncNcdpHoldTime.0'
More examples
Translate to a numeric OID
/usr/bin/snmptranslate -Pud -Ir -On -m 'CISCO-ATM-NETWORK-CLOCK-MIB' -M '/opt/observium/mibs/cisco:/opt/observium/mibs/rfc:/opt/observium/mibs/net-snmp' 'CISCO-ATM-NETWORK-CLOCK-MIB::cncNcdpHoldTime'

Syntax

millisecondsInteger32

Values & Constraints

Object Constraints
range: 75-60000

Conformance

Member of
cncGroup