CISCO-MOBILITY-TAP-MIB Table View

The Mobility Stream Table lists the data streams to be
intercepted. The same data stream may be required by multiple 
taps. 
          
          
This essentially provides options for packet selection, only 
some of which might be used. For example, if all the traffic to 
or from a subscriber is to be intercepted, one would configure 
an entry listing SubscriberID along with the SubscriberIDType  
corresponding to the stream that one wishes to intercept. 
          
          
The first index indicates which Mediation Device the 
intercepted traffic will be diverted to. The second index,
which indicates the specific intercept stream, permits multiple
classifiers to be used together.  For example, an IP stream
and a Mobility stream could both be listed in their respective
tables, yet still correspond to the same Mediation Device
entry.
          
Entries are added to this table via cmtapStreamStatus in  
accordance with the RowStatus convention.

cmtapStreamEntry row .1.3.6.1.4.1.9.9.672.1.1.2.1

A stream entry indicates a single data stream to be
intercepted to a Mediation Device. Many selected data
streams may go to the same application interface and many
application interfaces are supported.

Indexes

CISCO-TAP2-MIBcTap2MediationContentId CISCO-TAP2-MIBcTap2StreamIndex

Column	Syntax	OID
cmtapStreamCalledSubscriberIDType Identifies the type of address that is stored in the cmtapStreamCalledSubscriberID string.	CmtapSubscriberIDTyper/w Type Values: 1 unknown 2 msid 3 imsi 4 nai 5 esn 6 servedMdn	.1.3.6.1.4.1.9.9.672.1.1.2.1.1
cmtapStreamCalledSubscriberID A string used to identify the party being contacted. The type of this identification is determined by the cmtapStreamCalledSubscriberIDType object.	CmtapSubscriberIDr/w Type Constraints: range: 3..256	.1.3.6.1.4.1.9.9.672.1.1.2.1.2
cmtapStreamSubscriberIDType Identifies the type of address that is stored in the cmtapStreamSubscriberID string.	CmtapSubscriberIDTyper/w Type Values: 1 unknown 2 msid 3 imsi 4 nai 5 esn 6 servedMdn	.1.3.6.1.4.1.9.9.672.1.1.2.1.3
cmtapStreamSubscriberID A string used to identify the subscriber to tap. The type of this indentification is determined by the cmtapStreamSubscriberIDType object.	CmtapSubscriberIDr/w Type Constraints: range: 3..256	.1.3.6.1.4.1.9.9.672.1.1.2.1.4
cmtapStreamStorageType This object specifies the storage type of this conceptual row. If it is set to 'nonVolatile', this entry can be saved into non-volatile memory.	SNMPv2-TCStorageTyper/w Type Values: 1 other 2 volatile 3 nonVolatile 4 permanent 5 readOnly Description: Describes the memory realization of a conceptual row. A row which is volatile(2) is lost upon reboot. A row which is either nonVolatile(3), permanent(4) or readOnly(5), is backed up by stable storage. A row which is …	.1.3.6.1.4.1.9.9.672.1.1.2.1.5
cmtapStreamStatus The status of this conceptual row. This object manages creation, modification, and deletion of rows in this table. When any field must be changed, cmtapStreamStatus must be first set to 'notInService'.	SNMPv2-TCRowStatusr/w Type Values: 1 active 2 notInService 3 notReady 4 createAndGo 5 createAndWait 6 destroy Description: The RowStatus textual convention is used to manage the creation and deletion of conceptual rows, and is used as the value of the SYNTAX clause for the status column of a conceptual row (as described in Section 7.7.1 of …	.1.3.6.1.4.1.9.9.672.1.1.2.1.6
cmtapStreamLIIdentifier This object is an identifier assigned by a Law Enforcement Agency (LEA) to facilitate LI operations as defined in 3GPP TS 33.108 v8.7.0 standards document.	CmtapLawfulInterceptIDr/w Type Constraints: range: 3..256	.1.3.6.1.4.1.9.9.672.1.1.2.1.7
cmtapStreamLocationInfo This object indicates, if the userLocationInfo object should be included in the Intercept Related Information (IRI) messages sent by the gateway to mediation gateway(s) for interception taps. The userLoca…	SNMPv2-TCTruthValuer/w Type Values: 1 true 2 false Description: Represents a boolean value.	.1.3.6.1.4.1.9.9.672.1.1.2.1.8
cmtapStreamInterceptType This object indicates the intercept type of the tapped stream. The tap can be provisioned to intercept control messages (IRI) from the tapped stream, the payload (CC) messages from the tapped stream or both. The format…	Enumerationr/w Enumerated Values: 1 ccOnly 2 iriOnly 3 both	.1.3.6.1.4.1.9.9.672.1.1.2.1.9