CISCO-BUS-MIB Table View

A (conceptual) table representing all the instantiations
of BUSs on the designated device.  This table may or may not
allow the creation of rows depending on whether the LANE
service elements allow the separate creation of LES and BUS
components.  In the event that separate components are not
allowed then the MINIMUM-ACCESS detailed in the 
MODULE-COMPLIANCE should be used by those BUS implementations

busEntry row .1.3.6.1.4.1.9.9.40.1.1.1

An entry (conceptual row) in the busTable.

Indexes

busElanName busIndex

Column	Syntax	OID
busElanName The ELAN name of the designated bridge.	OctetString Constraints: range: 1-32	.1.3.6.1.4.1.9.9.40.1.1.1.1
busIndex A unique identifier for this particular BUS on this ELAN. This value must remain constant while the entry is in existence and during the operation of the agent (i.e. It is allowed to change after reboot). For i…	Integer32 Constraints: range: 1-2147483647	.1.3.6.1.4.1.9.9.40.1.1.1.2
busAtmAddrSpec The specified ATM address of the BUS on the interface of interest. Note that setting this object will have the side effect of reinitializing the BUS and consequently dropping all clients connected to it. If …	LAN-EMULATION-CLIENT-MIBAtmLaneAddressr/w Type Constraints: range: 0 range: 20	.1.3.6.1.4.1.9.9.40.1.1.1.3
busAtmAddrMask An address mask that when used with the busAtmAddrSpec, specifies the portion of the BUS' ATM address that is desired to be configured. Note that setting this object will result in the rei…	OctetStringr/w Constraints: range: 0-0 range: 20-20	.1.3.6.1.4.1.9.9.40.1.1.1.4
busAtmAddrActl The resultant ATM address in use by the BUS. This object is a product of the specified ATM address, mask and interaction with the switch via the ILMI.	LAN-EMULATION-CLIENT-MIBAtmLaneAddress Type Constraints: range: 0 range: 20	.1.3.6.1.4.1.9.9.40.1.1.1.5
busIfIndex The interface that a BUS will forward traffic over. The value specified for this object must equate to a value of ifIndex in the ifTable. The interface will be for that particular ATM port (the physical interface, not…	SNMPv2-SMIInteger32r/w Type Constraints: range: -2147483648..2147483647	.1.3.6.1.4.1.9.9.40.1.1.1.6
busSubIfNum Specifies the sub-interface number that the BUS will reside on. This sub-interface may be shared with a LEC or BUS of the same ELAN but is not required to do so. If no value is specified for this object at ro…	SNMPv2-SMIInteger32r/w Type Constraints: range: -2147483648..2147483647	.1.3.6.1.4.1.9.9.40.1.1.1.7
busUpTime The value of sysUpTime when this BUS became enabled.	SNMPv2-TCTimeStamp Based On: SNMPv2-SMITimeTicks Description: The value of the sysUpTime object at which a specific occurrence happened. The specific occurrence must be defined in the description of any object defined using this type. If sysUpTime is reset t…	.1.3.6.1.4.1.9.9.40.1.1.1.8
busLanType The type of legacy LAN that this LES emulates.	Enumerationr/w Enumerated Values: 1 dot3 2 dot5	.1.3.6.1.4.1.9.9.40.1.1.1.9
busMaxFrm The maximum frame size that the emulated LAN may accept.	Enumerationr/w Enumerated Values: 1516 dot3 4544 tr4Mb 9234 rfc1626 18190 tr16Mb	.1.3.6.1.4.1.9.9.40.1.1.1.10
busMaxFrmAge The maximum number of seconds a BUS will hold onto a packet for forwarding until it is dropped. Dropping a packet will result in the incrementing of the busFrmTimeOuts counter.	secondsInteger32r/w Constraints: range: 1-4	.1.3.6.1.4.1.9.9.40.1.1.1.11
busOutFwdOctets The number of octets that this BUS has forwarded since its initialization.	SNMPv2-SMICounter32 Type Constraints: range: 0..4294967295	.1.3.6.1.4.1.9.9.40.1.1.1.12
busOutFwdUcastFrms The number of frames that the BUS has forwarded which were unicast data frames including all control frames (i.e. they were flooded from the client).	SNMPv2-SMICounter32 Type Constraints: range: 0..4294967295	.1.3.6.1.4.1.9.9.40.1.1.1.13
busOutFwdNUcastFrms The number of frames that the BUS has forwarded which were multicast frames.	SNMPv2-SMICounter32 Type Constraints: range: 0..4294967295	.1.3.6.1.4.1.9.9.40.1.1.1.14
busFrmTimeOuts The number of frames dropped by the BUS due to time out.	SNMPv2-SMICounter32 Type Constraints: range: 0..4294967295	.1.3.6.1.4.1.9.9.40.1.1.1.15
busMultiFwdVpi The virtual path identifier for the multicast forward VCC.	CiscoVpiInteger Type Constraints: range: -1..255	.1.3.6.1.4.1.9.9.40.1.1.1.16
busMultiFwdVci The virtual channel identifier for the multicast forward VCC.	CiscoVciInteger Type Constraints: range: -1..65535	.1.3.6.1.4.1.9.9.40.1.1.1.17
busOperStatus This object reflects the actual state of the BUS which may differ from that of the busAdminStatus object. This can occur when the interface ifOperStatus is 'down' but the corresponding bu…	Enumeration Enumerated Values: 1 active 2 inactive	.1.3.6.1.4.1.9.9.40.1.1.1.18
busAdminStatus The desired state of the designated BUS as prescribed by the operator. The actions of the agent will, if at all possible, eventually result in the desired state being reflected in the busOperStatus.	Enumerationr/w Enumerated Values: 1 active 2 inactive	.1.3.6.1.4.1.9.9.40.1.1.1.19
busStatus The status of the BUS entry. This object cannot be set to active until the busIfIndex object has an appropiate value. Note that implementations that do not support separate LES/BUS entities may r…	SNMPv2-TCRowStatusr/w Type Values: 1 active 2 notInService 3 notReady 4 createAndGo 5 createAndWait 6 destroy Description: The RowStatus textual convention is used to manage the creation and deletion of conceptual rows, and is used as the value of the SYNTAX clause for the status column of a conceptual row (as described in Section 7.7.1 of …	.1.3.6.1.4.1.9.9.40.1.1.1.20

A (conceptual) table listing the clients associated
with a BUS.  Note that the local or network management
will not create or destroy rows in this table but
may only inspect what LECs are currently joined
with the BUS.

busClientEntry row .1.3.6.1.4.1.9.9.40.1.2.1

An entry (conceptual) row that denotes a client that
is establishing/has established a multicast send VC to
the BUS.

Indexes

busElanName busIndex busClientId

Column	Syntax	OID
busClientId A unique identifier for a LEC which is establishing/ has-established a multicast send VC to the BUS. The identifier only persists for as long as the LEC is associated with this particular BUS. If the LEC is dropped an…	SNMPv2-SMIInteger32 Type Constraints: range: -2147483648..2147483647	.1.3.6.1.4.1.9.9.40.1.2.1.1
busClientIfIndex The interface of the uni-directional multicast send connection between the LEC and BUS.	SNMPv2-SMIInteger32 Type Constraints: range: -2147483648..2147483647	.1.3.6.1.4.1.9.9.40.1.2.1.2
busClientMSendVpi The VPI of the uni-directional multicast send connection between the LEC and BUS.	CiscoVpiInteger Type Constraints: range: -1..255	.1.3.6.1.4.1.9.9.40.1.2.1.3
busClientMSendVci The VCI of the uni-directional multicast send connection between the LEC and BUS.	CiscoVciInteger Type Constraints: range: -1..65535	.1.3.6.1.4.1.9.9.40.1.2.1.4
busClientAtmAddress The address associated with the LANE client on the mulicast send VCC.	LAN-EMULATION-CLIENT-MIBAtmLaneAddress Type Constraints: range: 0 range: 20	.1.3.6.1.4.1.9.9.40.1.2.1.5