zxAdslLinePMConfPMSF

This configuration parameter defines the line states to be forced by 
the near-end ATU on this line. It is coded as an integer value with 
following definition:
    L0_FullOn   Force the line to transition from the L3 idle state 
                to the L0 full-on state. This transition requires 
                the (short) initialization procedures. After 
                reaching the L0 state, the line may transition into 
                or exit from the L2 low power state (if L2 state is 
                enabled). If the L0 state is not reached (after a 
                vendor discretionary number of retries and/or within
                a vendor discretionary timeout), then an 
                Initialization Failure occurs. Whenever the line is 
                in the L3 state, attemps shall be made to transition 
                to the L0 state until it is forced into another 
                state through this configuration parameter.
    L2_LowPower Force the line to transition from L0 full on to L2 
                low power state. This transition requires the entry 
                into L2 mode. This is a out-of-service test value 
                for triggering the L2 mode.
    L3_Idle     Force the line to transition from the L0 full-on or
                L2 low power state to the L3 idle state. This 
                transition requires the (orderly) shutdown procedure. 
                After reaching the L3 state, the line shall remain 
                in the L3 idle state until it is forced into another 
                state through this configuration parameter.
                  
    Forced line state transitions require the line to enter or exit 
    from the L3 idle state. These transitions are not restricted by 
    the Line state enabling parameter value.
                  
    NOTE - Supported for ADSL2/ADSL2plus ONLY.
           This configuration parameter maps to the AdminStatus of 
    the line, which is part of the GeneralInformationGroup object 
    group specified in RFC 2233, and may not need to be duplicated 
    in the ADSL MIB. See also RFC2662. The Administrative Status of 
    the line is UP when the line is forced to the L0 state and is 
    DOWN when the line is forced to the L3 state.

MIB

ZTE-DSL-LINE-EXT-MIB

OID

.1.3.6.1.4.1.3902.1004.4.1.1.1.1

Type

column

Access

readwrite

Status

current

Parent

zxAdslLineEntry

Table

zxAdslLineTable

Siblings

7