dot5RingStatus

TOKENRING-MIB · .1.3.6.1.2.1.10.9.1.1.3

Object

column Integer32

The current interface status which can
be used to diagnose fluctuating problems
that can occur on token rings, after a
station has successfully been added to
the ring.
   Before an open is completed, this
object has the value for the 'no status'
condition.  The dot5RingState and
dot5RingOpenStatus objects provide for
debugging problems when the station
can not even enter the ring.
    The object's value is a sum of
values, one for each currently applicable
condition.  The following values are
defined for various conditions:
              
        0 = No Problems detected
       32 = Ring Recovery
       64 = Single Station
      256 = Remove Received
      512 = reserved
     1024 = Auto-Removal Error
     2048 = Lobe Wire Fault
     4096 = Transmit Beacon
     8192 = Soft Error
    16384 = Hard Error
    32768 = Signal Loss
   131072 = no status, open not completed.

Context

MIB: TOKENRING-MIB
OID: .1.3.6.1.2.1.10.9.1.1.3
Type: column
Access: readonly
Status: current
Parent: dot5Entry
Table: dot5Table
Siblings: 9

Syntax

Integer32

Values & Constraints

Object Constraints

range: 0-262143

Related Objects

Sibling Objects

Object	Type	Syntax	OID
dot5IfIndex The value of this object identifies the 802.5 interface for which this entry contains management information. The value of this object for a particular interface has the same val…	column	SNMPv2-SMIInteger32	`.1.3.6.1.2.1.10.9.1.1.1`
dot5LastBeaconSent The value of MIB-II's sysUpTime object at which the local system last transmitted a Beacon frame on this interface.	column	SNMPv2-TCTimeStamp	`.1.3.6.1.2.1.10.9.1.1.10`
dot5Commands When this object is set to the value of open(2), the station should go into the open state. The progress and success of the open is given by the values of the objects dot5RingSta…	column	Enumeration	`.1.3.6.1.2.1.10.9.1.1.2`
dot5RingState The current interface state with respect to entering or leaving the ring.	column	Enumeration	`.1.3.6.1.2.1.10.9.1.1.4`
dot5RingOpenStatus This object indicates the success, or the reason for failure, of the station's most recent attempt to enter the ring.	column	Enumeration	`.1.3.6.1.2.1.10.9.1.1.5`
dot5RingSpeed The ring-speed at the next insertion into the ring. Note that this may or may not be different to the current ring-speed which is given by MIB-II's ifSpeed. For interfaces which…	column	Enumeration	`.1.3.6.1.2.1.10.9.1.1.6`
dot5UpStream The MAC-address of the up stream neighbor station in the ring.	column	SNMPv2-TCMacAddress	`.1.3.6.1.2.1.10.9.1.1.7`
dot5ActMonParticipate If this object has a value of true(1) then this interface will participate in the active monitor selection process. If the value is false(2) then it will not. Setting this object…	column	Enumeration	`.1.3.6.1.2.1.10.9.1.1.8`
dot5Functional The bit mask of all Token Ring functional addresses for which this interface will accept frames.	column	SNMPv2-TCMacAddress	`.1.3.6.1.2.1.10.9.1.1.9`