dot5Commands
TOKENRING-MIB ·
.1.3.6.1.2.1.10.9.1.1.2
Object
column
r/w
Enumeration
When this object is set to the value of
open(2), the station should go into the
open state. The progress and success of
the open is given by the values of the
objects dot5RingState and
dot5RingOpenStatus.
When this object is set to the value
of reset(3), then the station should do
a reset. On a reset, all MIB counters
should retain their values, if possible.
Other side affects are dependent on the
hardware chip set.
When this object is set to the value
of close(4), the station should go into
the stopped state by removing itself
from the ring.
Setting this object to a value of
noop(1) has no effect.
When read, this object always has a
value of noop(1).
The open(2) and close(4) values
correspond to the up(1) and down(2) values
of MIB-II's ifAdminStatus and ifOperStatus,
i.e., the setting of ifAdminStatus and
dot5Commands affects the values of both
dot5Commands and ifOperStatus.
Context
- MIB
- TOKENRING-MIB
- OID
.1.3.6.1.2.1.10.9.1.1.2- Type
- column
- Access
- readwrite
- Status
- current
- Parent
- dot5Entry
- Table
- dot5Table
- Siblings
- 9
Syntax
Enumeration
Values & Constraints
Enumerated Values
1 | noop |
2 | open |
3 | reset |
4 | close |
Related Objects
Sibling Objects
| Object | Type | Syntax | OID |
|---|---|---|---|
| dot5IfIndex The value of this object identifies the
802.5 interface for which this entry
contains management information. The
value of this object for a particular
interface has the same val… | column | SNMPv2-SMIInteger32 | .1.3.6.1.2.1.10.9.1.1.1 |
| dot5LastBeaconSent The value of MIB-II's sysUpTime object at which
the local system last transmitted a Beacon frame
on this interface. | column | SNMPv2-TCTimeStamp | .1.3.6.1.2.1.10.9.1.1.10 |
| dot5RingStatus The current interface status which can
be used to diagnose fluctuating problems
that can occur on token rings, after a
station has successfully been added to
the ring.
Before a… | column | Integer32 | .1.3.6.1.2.1.10.9.1.1.3 |
| dot5RingState The current interface state with respect
to entering or leaving the ring. | column | Enumeration | .1.3.6.1.2.1.10.9.1.1.4 |
| dot5RingOpenStatus This object indicates the success, or the
reason for failure, of the station's most
recent attempt to enter the ring. | column | Enumeration | .1.3.6.1.2.1.10.9.1.1.5 |
| dot5RingSpeed The ring-speed at the next insertion into
the ring. Note that this may or may not be
different to the current ring-speed which is
given by MIB-II's ifSpeed. For interfaces
which… | column | Enumeration | .1.3.6.1.2.1.10.9.1.1.6 |
| dot5UpStream The MAC-address of the up stream neighbor
station in the ring. | column | SNMPv2-TCMacAddress | .1.3.6.1.2.1.10.9.1.1.7 |
| dot5ActMonParticipate If this object has a value of true(1) then
this interface will participate in the
active monitor selection process. If the
value is false(2) then it will not.
Setting this object… | column | Enumeration | .1.3.6.1.2.1.10.9.1.1.8 |
| dot5Functional The bit mask of all Token Ring functional
addresses for which this interface will
accept frames. | column | SNMPv2-TCMacAddress | .1.3.6.1.2.1.10.9.1.1.9 |