fsLaPortChannelSelectionPolicyBitList
SUPERMICRO-LA-MIB ·
.1.3.6.1.4.1.10876.101.1.63.2.1.1.11
Object
This object is used to set the Link selection policy to be
used by the port-channel.
A FOUR BYTE integer is used for setting the selecting policy.
Each BIT in the four byte integer, represents a particular
selection policy.
The maping between the bit positions & the selection policy is
as follows:
macSrc(0), -- source MAC
macDst(1), -- destination MAC
vlanId(2), -- VLAN ID
isid(3), -- ISID
mplsLabel0(4), -- MPLS Label 0 ( top label )
mplsLabel1(5), -- MPLS Label 1 ( inner label 1)
mplsLabel2(6), -- MPLS Label 2 ( inner label 2)
ipSrc(7), -- Source IP address
ipDst(8), -- Destination IP address
ip6Src(9), -- Source IPv6 address
ip6Dst(10), -- Destination IPv6 address
l3Protocol(11),-- Layer 3 protocol specified in IP header
l4SrcPort(12), -- Layer 4 source port specified in L4 header ( tcp/udp port )
l4DstPort (13) -- Layer 4 destination port specified in L4 header ( tcp/udp port )
The remaining bits are unused. Selection of multiple bits
implies selection of corresponding attributes in the
packet header for configuring the port-channel selection policy.
For example if the bits 0 and 1 are set, then the selection
policy is based on source mac and destination mac.
This object would return failure if the selected bitlist is not supported in the
system(hardware)
Context
- MIB
- SUPERMICRO-LA-MIB
- OID
.1.3.6.1.4.1.10876.101.1.63.2.1.1.11- Type
- column
- Access
- readwrite
- Status
- current
- Parent
- fsLaPortChannelEntry
- Table
- fsLaPortChannelTable
- Siblings
- 31
Syntax
SNMPv2-SMIInteger32
- Source
- SNMPv2-SMIInteger32
- Base type
Integer32
Values & Constraints
Type Constraints
range: -2147483648..2147483647
Related Objects
Sibling Objects
| Object | Type | Syntax | OID |
|---|---|---|---|
| fsLaPortChannelIfIndex The ifIndex of the port-channel(Aggregator's
interface index). | column | IF-MIBInterfaceIndex | .1.3.6.1.4.1.10876.101.1.63.2.1.1.1 |
| fsLaPortChannelMaxPorts This object specifies the maximun number of
ports that can attach to a port-channel. | column | Integer32 | .1.3.6.1.4.1.10876.101.1.63.2.1.1.10 |
| fsLaPortChannelDLAGDistributingPortIndex This object is used to configure the distributing
port on which D-LAG periodic-sync and
D-LAG event-update messages will be sent/received
for D-LAG internal communication between … | column | IF-MIBInterfaceIndexOrZero | .1.3.6.1.4.1.10876.101.1.63.2.1.1.12 |
| fsLaPortChannelDLAGSystemID This object is used to configure the common System ID in
D-LAG nodes to be used for communicating with the peer node
when D-LAG status is enabled.
Since all the D-L… | column | SNMPv2-TCMacAddress | .1.3.6.1.4.1.10876.101.1.63.2.1.1.13 |
| fsLaPortChannelDLAGSystemPriority This object is used for configuring common system priority in
D-LAG nodes to be used for communicating with the peer node when
D-LAG status is enabled.
Since all th… | column | Integer32 | .1.3.6.1.4.1.10876.101.1.63.2.1.1.14 |
| fsLaPortChannelDLAGPeriodicSyncTime This object is used to configure the D-LAG periodic sync timer
used in Distributed Link Aggregation.
Periodic sync timer is used to configure the transmission
interval of D-LAG pe… | column | milliseconds Unsigned32 | .1.3.6.1.4.1.10876.101.1.63.2.1.1.15 |
| fsLaPortChannelDLAGMSSelectionWaitTime This object is used to configure the period for the
master slave selection wait timer used in Distributed
Link Aggregation.
This object is applicable, only if D-LA… | column | milliseconds Unsigned32 | .1.3.6.1.4.1.10876.101.1.63.2.1.1.16 |
| fsLaPortChannelDLAGRolePlayed This object is used to hold the current role played by the device
participating in Distributed LAG.
This object is applicable, only if D-LAG status and D-LAG
redund… | column | Enumeration | .1.3.6.1.4.1.10876.101.1.63.2.1.1.17 |
| fsLaPortChannelDLAGStatus This object is used to enable or disable the D-LAG
functionality.
This object can be modified irrespective of whether
corresponding port-channel is enabled/disabled… | column | Enumeration | .1.3.6.1.4.1.10876.101.1.63.2.1.1.18 |
| fsLaPortChannelDLAGRedundancy This object is used to enable/disable the redundancy feature
in D-LAG node.
When D-LAG redundancy feature is enabled, master-slave-selection
algorithm can be used t… | column | Enumeration | .1.3.6.1.4.1.10876.101.1.63.2.1.1.19 |
| fsLaPortChannelGroup An index that uniquely identifies an entry in this table. | column | LacpKey | .1.3.6.1.4.1.10876.101.1.63.2.1.1.2 |
| fsLaPortChannelDLAGMaxKeepAliveCount This read-only mib object is used to provide keep alive
mechanism when D-LAG status is enabled.
Each D-LAG node will have a Max Keep alive count and each D-LAG
node maintains sepe… | column | Integer32 | .1.3.6.1.4.1.10876.101.1.63.2.1.1.20 |
| fsLaPortChannelDLAGPeriodicSyncPduTxCount This object is used when Distributing feature is enabled in a
node to hold the number of periodic-sync PDUs sent on the
distributing port. | column | SNMPv2-SMICounter32 | .1.3.6.1.4.1.10876.101.1.63.2.1.1.21 |
| fsLaPortChannelDLAGPeriodicSyncPduRxCount This object is used when Distributing feature is enabled in a
node to hold the number of periodic-sync PDUs received on the
distributing port. | column | SNMPv2-SMICounter32 | .1.3.6.1.4.1.10876.101.1.63.2.1.1.22 |
| fsLaPortChannelDLAGEventUpdatePduTxCount This object is used when Distributing feature is enabled in a
node to hold the number of event-update PDUs sent on the
distributing port. | column | SNMPv2-SMICounter32 | .1.3.6.1.4.1.10876.101.1.63.2.1.1.23 |
| fsLaPortChannelDLAGEventUpdatePduRxCount This object is used when Distributing feature is enabled in a
node to hold the number of event-update PDUs received on the
distributing port. | column | SNMPv2-SMICounter32 | .1.3.6.1.4.1.10876.101.1.63.2.1.1.24 |
| fsLaPortChannelDLAGElectedAsMasterCount This object is used when Distributing feature and redundancy
feature both are enabled in a D-LAG node to hold the number of
times the port-channel has been selected as master. | column | SNMPv2-SMICounter32 | .1.3.6.1.4.1.10876.101.1.63.2.1.1.25 |
| fsLaPortChannelDLAGElectedAsSlaveCount This object is used when Distributing feature and redundancy
feature both are enabled in a D-LAG node to hold the number of
times the port-channel has been selected as slave. | column | SNMPv2-SMICounter32 | .1.3.6.1.4.1.10876.101.1.63.2.1.1.26 |
| fsLaPortChannelTrapTxCount The number of trap messages sent from the port-channel. | column | SNMPv2-SMICounter32 | .1.3.6.1.4.1.10876.101.1.63.2.1.1.27 |
| fsLaPortChannelDLAGDistributingPortList This object is used to configure the distributing
port list on which D-LAG periodic-sync and
D-LAG event-update messages will be sent/received
for D-LAG internal communication bet… | column | Q-BRIDGE-MIBPortList | .1.3.6.1.4.1.10876.101.1.63.2.1.1.28 |
| fsLaPortChannelFallback This object is used to enable or disable fallback on this port-channel. | column | Enumeration | .1.3.6.1.4.1.10876.101.1.63.2.1.1.29 |
| fsLaPortChannelAdminMacAddress deprecated This object is used for configuring MacAddress that is
to be used by the port-channel when fsLaPortChannelMacSelection
is force.
WARNING:The value configured should not conflict
… | column | SNMPv2-TCMacAddress | .1.3.6.1.4.1.10876.101.1.63.2.1.1.3 |
| fsLaPortChannelFallbackTime Duration of a port to bundle state. | column | SNMPv2-SMITimeTicks | .1.3.6.1.4.1.10876.101.1.63.2.1.1.30 |
| fsLaPortChannelFallbackState This read-only object is used to display the fallback state in this port-channel.
init(0) - Fallback is disabled in this port-channel.
inactive(1) - Fallback is en… | column | Enumeration | .1.3.6.1.4.1.10876.101.1.63.2.1.1.31 |
| fsLaPortChannelFallbackSysId This object is used to specify which MLAG portal system can bring
up the local aggregator port if LACPDU is not received from the
LACP partner.
If this object is configured to v… | column | Integer32 | .1.3.6.1.4.1.10876.101.1.63.2.1.1.32 |
| fsLaPortChannelMacSelection deprecated Indicates the MAC address selection method for
for the port-channel.
Dynamic - System will reserve certain MAC address
for aggregators. These MAC address are
d… | column | Enumeration | .1.3.6.1.4.1.10876.101.1.63.2.1.1.4 |
| fsLaPortChannelMode Current Operating Channel Mode of the port
Lacp(1) - forcing the port to negotiate with the
partner.
manual(2) - force the port to enable channeling (Manual).
dis… | column | PortLaMode | .1.3.6.1.4.1.10876.101.1.63.2.1.1.5 |
| fsLaPortChannelPortCount The number of ports actually configured to the port-channel | column | SNMPv2-SMIInteger32 | .1.3.6.1.4.1.10876.101.1.63.2.1.1.6 |
| fsLaPortChannelActivePortCount This object will give the number of ports that are attached to the
port-channel and actively carrying data traffic on the link. | column | SNMPv2-SMIInteger32 | .1.3.6.1.4.1.10876.101.1.63.2.1.1.7 |
| fsLaPortChannelSelectionPolicy Link selection policy to be used by the port-channel.
Selection policy isid implies selection based on Service-instance
and is applicable only in Provider BackBone bridge. | column | Enumeration | .1.3.6.1.4.1.10876.101.1.63.2.1.1.8 |
| fsLaPortChannelDefaultPortIndex The ifIndex of the default port that gets attached to the
aggregator. A value of 0 means there is no default port for
this port-channel.
If this object is set to 0, it will remov… | column | IF-MIBInterfaceIndexOrZero | .1.3.6.1.4.1.10876.101.1.63.2.1.1.9 |