sfpInternalWarnings
SIAE-SFP-MIB ·
.1.3.6.1.4.1.3373.1103.74.7.1.12
Object
column
Bits
This contains the state of the SFP internal warning register. A bit is set for each warning that is active. located at I2C address 0xa2, Byte 116 & 117 (MSB, LSB) mask 0xffc0
Context
- MIB
- SIAE-SFP-MIB
- OID
.1.3.6.1.4.1.3373.1103.74.7.1.12- Type
- column
- Access
- readonly
- Status
- current
- Parent
- sfpDiagnosticEntry
- Table
- sfpDiagnosticTable
- Siblings
- 11
Syntax
Bits
Values & Constraints
Enumerated Values
0 | sfpIntWarnTempHigh |
1 | sfpIntWarnTempLow |
2 | sfpIntWarnVoltageHigh |
3 | sfpIntWarnVoltageLow |
4 | sfpIntWarnTxBiasHigh |
5 | sfpIntWarnTxBiasLow |
6 | sfpIntWarnTxPowerHigh |
7 | sfpIntWarnTxPowerLow |
8 | sfpIntWarnRxPowerHigh |
9 | sfpIntWarnRxPowerLow |
Related Objects
Sibling Objects
| Object | Type | Syntax | OID |
|---|---|---|---|
| sfpDiagnosticValid if False, then the SFP data in this table is not valid. This
will be set to False if the SFP module is not installed, or if
the I/O card that contains the SFP is not installed or … | column | SNMPv2-TCTruthValue | .1.3.6.1.4.1.3373.1103.74.7.1.1 |
| sfpRxPower This contains the internally measured RX optical power. Units
are in uW (micro Watts), and range from 0 to 6554uW (6.535mW).
Located at I2C address 0xa2, Bytes 104 & 105 (MSB, LSB) | column | microWatts (uW) Integer32 | .1.3.6.1.4.1.3373.1103.74.7.1.10 |
| sfpInternalAlarms This contains the state of the SFP internal alarm register. A
bit is set for each alarm that is active. located at I2C
address 0xa2, Byte 112 & 113 (MSB, LSB) mask 0xffc0 | column | Bits | .1.3.6.1.4.1.3373.1103.74.7.1.11 |
| sfpLOSPinOut This contains the T/F state of the SFP LOS (output) pin. It is
True if the SFP has detected Loss-Of-Signal. located at I2c
address 0xa2, address: 110, mask 0x02 | column | SNMPv2-TCTruthValue | .1.3.6.1.4.1.3373.1103.74.7.1.2 |
| sfpTxFaultPinOut This contains the T/F state of the SFP Tx Fault (output) pin.
It is True if the SFP has detected a Tx fault condition.
located at I2C address 0xa2, Byte 110, mask 0x04 | column | SNMPv2-TCTruthValue | .1.3.6.1.4.1.3373.1103.74.7.1.3 |
| sfpRateSelectPinIn This contains the T/F state of the SFP RX Rate Select (input)
pin. This function is not implemented on Finisar SFPs. located
at I2C address 0xa2, Byte 110, mask 0x10 | column | SNMPv2-TCTruthValue | .1.3.6.1.4.1.3373.1103.74.7.1.4 |
| sfpTxDisablePinIn This contains the T/F state of the SFP TX Disable (input) pin.
located at I2C address 0xa2, Byte 110, mask 0x80 | column | SNMPv2-TCTruthValue | .1.3.6.1.4.1.3373.1103.74.7.1.5 |
| sfpTemperature This contains the internal temperature of the SFP in tehnth of
Celsius degrees. Range is from -128.0C to +128.0C, but is only
valid from -40.0C to +125.0C with an accuracy of +/-… | column | C/10 Temperature | .1.3.6.1.4.1.3373.1103.74.7.1.6 |
| sfpVoltage This contains the internally measured SFP supply voltage
(Vcc). Units are in milliVolts (3210 = 3.21V). Range is 0 to
6.554V. Located at I2C address 0xa2, Bytes 98 & 99 (MSB, LSB) | column | milliVolts (mV) Integer32 | .1.3.6.1.4.1.3373.1103.74.7.1.7 |
| sfpTxBias This contains the internally measured SFP TX laser bias
current. Units are in microAmps, and range from 0 to 131000uA
(131mA). Located at I2C address 0xa2, Bytes 100 & 101 (MSB, L… | column | microAmps (uA) Integer32 | .1.3.6.1.4.1.3373.1103.74.7.1.8 |
| sfpTxPower This contains the internally measured TX output power. Units
are in uW (micro Watts), and range from 0 to 6554uW (6.535mW).
This value is not valid if the transmitter is disabled.… | column | microWatts (uW) Integer32 | .1.3.6.1.4.1.3373.1103.74.7.1.9 |