linkXpd

SIAE-RADIO-SYSTEM-MIB · .1.3.6.1.4.1.3373.1103.80.17.1.26
MIB view Table view

Object

column deprecated SNMPv2-SMIInteger32 
Cross-Polarization Discrimination, in tenths of dB, is the
difference between the received signal power of the
co-polarized main beam, and it componemt received on the
cross-polarized signal.
This object shows an extimated value of the XPD performed by 
the cross-polarization interference canceller (XPIC).
This means that the measure is reliable if:
- XPIC is on (linkType is radio2p0Xpic(4), or radio2p2XpicHS(5),
              or radio2p2XpicFD(6))
- Alarm radioDemodulatorFailAlarm is cleared.
- XPD is not too high, since without cross-polar interference
  the canceller is not able to works well. Basically, in this
  condition, the extimated XPD is greater than the real one.

Context

MIB
SIAE-RADIO-SYSTEM-MIB
OID
.1.3.6.1.4.1.3373.1103.80.17.1.26
Type
column
Access
readonly
Status
deprecated
Parent
linkStatusEntry
Table
linkStatusTable
Siblings
25

Syntax

SNMPv2-SMIInteger32
Source
SNMPv2-SMIInteger32
Base type
Integer32

Values & Constraints

Type Constraints
range: -2147483648..2147483647

Related Objects

Sibling Objects
ObjectTypeSyntaxOID
linkPolIndex
This object identifies the radio polarization. In XPIC radio link identifies one of the polarizations.
columnInteger32.1.3.6.1.4.1.3373.1103.80.17.1.1
linkTxETHCapacity
This object reports (in Kbits/sec) the transmitted payload capacity used by the Ethernet
columnSNMPv2-SMIInteger32.1.3.6.1.4.1.3373.1103.80.17.1.10
linkRxETHCapacity
This object reports (in Kbits/sec) the received payload capacity used by the Ethernet
columnSNMPv2-SMIInteger32.1.3.6.1.4.1.3373.1103.80.17.1.11
linkTxTDMCapacity
This object reports the capacity in kbit/sec reserved to TDM tributaries in tx ACM profile.
columnSNMPv2-SMIInteger32.1.3.6.1.4.1.3373.1103.80.17.1.12
linkRxTDMCapacity
This object reports the capacity in kbit/sec reserved to TDM tributaries in rx ACM profile.
columnSNMPv2-SMIInteger32.1.3.6.1.4.1.3373.1103.80.17.1.13
linkRescueModulation
This object is the modulation used when the remote terminal is unreachable, ie traffic on radio link is down.
columnBitsPerSymbol.1.3.6.1.4.1.3373.1103.80.17.1.14
linkReducedCapacityAlarm
The equipment works in reduced capacity
columnSIAE-ALARM-MIBAlarmStatus.1.3.6.1.4.1.3373.1103.80.17.1.15
linkLinkTelemetryFailAlarm
Fail of link telemetry communication channel with associated Severity
columnSIAE-ALARM-MIBAlarmStatus.1.3.6.1.4.1.3373.1103.80.17.1.16
linkIdMismatchAlarm
Link Identification Alarm with associated Severity
columnSIAE-ALARM-MIBAlarmStatus.1.3.6.1.4.1.3373.1103.80.17.1.17
linkRadioEocAlarm
Fail of Radio Eoc link communication channel with associated Severity
columnSIAE-ALARM-MIBAlarmStatus.1.3.6.1.4.1.3373.1103.80.17.1.18
linkSetupMismatchAlarm
The local setup doesn't match the setup of remote terminal
columnSIAE-ALARM-MIBAlarmStatus.1.3.6.1.4.1.3373.1103.80.17.1.19
linkAcmRxProfile
This object reports the ACM profile number in use in the radio Rx. It is the linkAcmProfileId of linkAcmTable. Label is linkAcmProfileLabel from linkAcmTable
columnSNMPv2-SMIInteger32.1.3.6.1.4.1.3373.1103.80.17.1.2
linkRescueSetupAlarm
The equipment is using the setup relative to the rescue modulation
columnSIAE-ALARM-MIBAlarmStatus.1.3.6.1.4.1.3373.1103.80.17.1.20
linkXpicProcedureBlockAlarm
Only for XPIC equipment configurations. Equipment Controller XPIC procedure Alarm control with associated Severity
columnSIAE-ALARM-MIBAlarmStatus.1.3.6.1.4.1.3373.1103.80.17.1.21
linkXpicRemTxOffAlarm
Only for XPIC equipment configurations. Remote TX OFF command with associated Severity
columnSIAE-ALARM-MIBAlarmStatus.1.3.6.1.4.1.3373.1103.80.17.1.22
linkRemoteIduAlarmSynthesis
Synthesis of the remote IDU alarms
columnSIAE-ALARM-MIBAlarmStatus.1.3.6.1.4.1.3373.1103.80.17.1.23
linkNotMatchingRadiosAlarm
Radios of the link does not have matched parameters.
columnSIAE-ALARM-MIBAlarmStatus.1.3.6.1.4.1.3373.1103.80.17.1.24
linkConfigurationInProgress
The link is being configured and the table linkSettingsTable is not available for modifying parameters.
columnEnumeration.1.3.6.1.4.1.3373.1103.80.17.1.25
linkAcmTxProfile
This object reports the ACM profile number in use in the radio Tx. It is the linkAcmProfileId of linkAcmTable. Label is linkAcmProfileLabel from linkAcmTable
columnSNMPv2-SMIInteger32.1.3.6.1.4.1.3373.1103.80.17.1.3
linkAcmRxProfileLabel
ASCII string used to describe current acm rx profile
columnOctetString.1.3.6.1.4.1.3373.1103.80.17.1.4
linkAcmTxProfileLabel
ASCII string used to describe current acm tx profile
columnOctetString.1.3.6.1.4.1.3373.1103.80.17.1.5
linkAcmRxModulation
This object is the type of modulation of the Rx profile in use.
columnBitsPerSymbol.1.3.6.1.4.1.3373.1103.80.17.1.6
linkAcmTxModulation
This object is the type of modulation of the Tx profile in use.
columnBitsPerSymbol.1.3.6.1.4.1.3373.1103.80.17.1.7
linkAcmRxCode
This object is the type of codificator of the Rx profile in use.
columnEnumeration.1.3.6.1.4.1.3373.1103.80.17.1.8
linkAcmTxCode
This object is the type of codificator of the Tx profile in use.
columnEnumeration.1.3.6.1.4.1.3373.1103.80.17.1.9