rcSerialPortIfIndex

RUGGEDCOM-SERIAL-MIB · .1.3.6.1.4.1.15004.4.6.1.1.1.2

MIB view Table view

Object

column IF-MIBInterfaceIndex

The value of ifIndex for the port. This value is same as 
'rs232PortIndex' which is the index  used for 'rs232PortTable'
in RS-232-MIB.

Context

MIB: RUGGEDCOM-SERIAL-MIB
OID: .1.3.6.1.4.1.15004.4.6.1.1.1.2
Type: column
Access: readonly
Status: current
Parent: rcSerialPortEntry
Table: rcSerialPortTable
Siblings: 9

Syntax

IF-MIBInterfaceIndex

Source: IF-MIBInterfaceIndex
Base type: Integer32

Values & Constraints

Type Constraints

range: 1..2147483647

Related Objects

Sibling Objects

Object	Type	Syntax	OID
rcSerialPortNumber The physical Serial Port Number of the device for which this Entry contains configuration settings.	column	Integer32	`.1.3.6.1.4.1.15004.4.6.1.1.1.1`
rcSerialRxtoTxDelay The minimum amount of time in ms that the transmission of a new message should delay after the last message is received through the serial port. This parameter is…	column	milliseconds Integer32	`.1.3.6.1.4.1.15004.4.6.1.1.1.10`
rcSerialProtocol A Serial Protocol supported on the Serial Port represented by this entry.	column	RcSerProtocol	`.1.3.6.1.4.1.15004.4.6.1.1.1.3`
rcSerialPortType A Serial Port Type supported on the Serial Port represented by this entry.	column	RcSerPortType	`.1.3.6.1.4.1.15004.4.6.1.1.1.4`
rcSerialForceHD Enables forcing half duplex mode of operation on the Serial Port. While sending data out of the serial port all received data are ignored. This mode of operation …	column	Enumeration	`.1.3.6.1.4.1.15004.4.6.1.1.1.5`
rcSerialTurnAround The amount of delay between the transmission of individual messages out of the serial port. For 'rcSerialProtocol' object value modbusServer(3) this value must be n…	column	milliseconds Integer32	`.1.3.6.1.4.1.15004.4.6.1.1.1.6`
rcSerialPostTxDelay The number of bits needed to generate required delay with configured baudrate('rs232PortOutSpeed') after the last bit of the packet was sent out before serial UART starts listenin…	column	bits Integer32	`.1.3.6.1.4.1.15004.4.6.1.1.1.7`
rcSerialHoldTime The maximum amount of time in ms that serial packet can be held in the queue before being sent to the serial line. Time is measured from the moment the packet is r…	column	milliseconds Integer32	`.1.3.6.1.4.1.15004.4.6.1.1.1.8`
rcSerialDscp The value of DS byte to be set in the IP header. DS byte setting is supported in the egress direction only.	column	Integer32	`.1.3.6.1.4.1.15004.4.6.1.1.1.9`