bgpPeerKeepAliveConfig
RAD-RadBgp-MIB ·
.1.3.6.1.4.1.164.11.4.2.1.11
Object
Time interval in seconds for the KeepAlive configured for this BGP speaker with this peer. The value of this object will only determine the KEEPALIVE messages' frequency relative to the value specified in bgpPeerHoldTimeConfigd; the actual time interval for the KEEPALIVE messages is indicated by bgpPeerKeepAlive. A reasonable maximum value for this timer would be configured to be one third of that of bgpPeerHoldTimeConfigd. If the value of this object is zero (0), no periodical KEEPALIVE messages are sent to the peer after the BGP connection has been established. The suggested value for this timer is 30 seconds.
Context
- MIB
- RAD-RadBgp-MIB
- OID
.1.3.6.1.4.1.164.11.4.2.1.11- Type
- column
- Access
- readwrite
- Status
- current
- Units
- seconds
- Parent
- bgpPeerEntry
- Table
- bgpPeerTable
- Siblings
- 22
Syntax
seconds SNMPv2-SMIUnsigned32
- Source
- SNMPv2-SMIUnsigned32
- Base type
Unsigned32
Values & Constraints
Type Constraints
range: 0..4294967295
Related Objects
Sibling Objects
| Object | Type | Syntax | OID |
|---|---|---|---|
| bgpPeerRemoteAddrType The address family of the remote end of the peering session. | column | INET-ADDRESS-MIBInetAddressType | .1.3.6.1.4.1.164.11.4.2.1.1 |
| bgpPeerHoldTimeConfig Time interval in seconds for the Hold Time configured
for this BGP speaker with this peer. This value
is placed in an OPEN message sent to this peer by
this BGP speaker, and is c… | column | seconds SNMPv2-SMIUnsigned32 | .1.3.6.1.4.1.164.11.4.2.1.10 |
| bgpPeerHoldTime Time interval in seconds for the Hold Timer
established with the peer. The value of this
is calculated by this BGP speaker by using the
smaller of the value in bgpPeerHoldTimeCon… | column | seconds SNMPv2-SMIInteger32 | .1.3.6.1.4.1.164.11.4.2.1.12 |
| bgpPeerKeepAlive Time interval in seconds for the KeepAlive timer
established with the peer. The value of this
is calculated by this BGP speaker such that, when
compared with bgpPeerHoldTime, it … | column | seconds SNMPv2-SMIInteger32 | .1.3.6.1.4.1.164.11.4.2.1.13 |
| bgpPeerConfigMaxPrefix This object is used to limit the number of
prefixes that can be accepted from this peer.
Setting bgpPeerConfigMaxPrfx to a non-zero value sets the
maximum number of… | column | SNMPv2-SMIInteger32 | .1.3.6.1.4.1.164.11.4.2.1.14 |
| bgpPeerPassword The password used by this peer. | column | OctetString | .1.3.6.1.4.1.164.11.4.2.1.15 |
| bgpPeerCapabilitySent The capabilities announced to the peer on the most recent
Open message sent to the peer. This field is set to zero
before the first Open message is sent to the peer, and
is uncha… | column | BgpCapabilities | .1.3.6.1.4.1.164.11.4.2.1.16 |
| bgpPeerCapabilityRcv The capabilities received on the most recent Open message
received from the peer. This field is set to zero before
the first Open message is received from the peer, and is
unchan… | column | BgpCapabilities | .1.3.6.1.4.1.164.11.4.2.1.17 |
| bgpPeerCapabilityNegotiated The capabilities negotiated for the session with the peer.
This field is set to zero before Open messages have been
exchanged with the peer, and is unchanged if the session
comes … | column | BgpCapabilities | .1.3.6.1.4.1.164.11.4.2.1.18 |
| bgpPeerSelectedLocalAddr The address selected for the local end of the peering
session. If a connection exists and bgpPeerLocalAddr is
specified then these two fields will be identical. | column | INET-ADDRESS-MIBInetAddress | .1.3.6.1.4.1.164.11.4.2.1.19 |
| bgpPeerRemoteAddr The address of the remote end of the peering session. | column | INET-ADDRESS-MIBInetAddress | .1.3.6.1.4.1.164.11.4.2.1.2 |
| bgpPeerSelectedLocalPort The local port selected for transport connection between the
BGP peers. A value of zero implies that there is currently
no connection to this peer. | column | INET-ADDRESS-MIBInetPortNumber | .1.3.6.1.4.1.164.11.4.2.1.20 |
| bgpPeerSelectedRemotePort The remote port selected for the transport connection between
the BGP peers. A value of zero implies that there is
currently no connection to this peer. | column | INET-ADDRESS-MIBInetPortNumber | .1.3.6.1.4.1.164.11.4.2.1.21 |
| bgpPeerClearCmd Reset action to be performed on BGP session. | column | Enumeration | .1.3.6.1.4.1.164.11.4.2.1.22 |
| bgpPeerDescr This object is used as a varbind in the BGP Traps
the value of this object should be the IP address
contained in the remote peer 'bgpPeerRemoteAddr' | column | SNMP-FRAMEWORK-MIBSnmpAdminString | .1.3.6.1.4.1.164.11.4.2.1.23 |
| bgpPeerFsmState The BGP peer's FSM state. | column | BgpPeerStates | .1.3.6.1.4.1.164.11.4.2.1.3 |
| bgpPeerRowStatus This object type reflects the status of the row within the
agent. An instance of this row is returned by the agent to
reflect the validity of the current state of this row. | column | SNMPv2-TCRowStatus | .1.3.6.1.4.1.164.11.4.2.1.4 |
| bgpPeerLocalAddrType The address family of the local end of the peering session. | column | INET-ADDRESS-MIBInetAddressType | .1.3.6.1.4.1.164.11.4.2.1.5 |
| bgpPeerLocalAddr The address of the local end of the peering session.
If a zero length address is
used, DC-BGP will not bind a specific address but use whatever
is available. In this case the
bgp… | column | INET-ADDRESS-MIBInetAddress | .1.3.6.1.4.1.164.11.4.2.1.6 |
| bgpPeerRemoteAs The remote autonomous system number. This field can only be
changed when the BGP peer entry is not active. | column | BgpAutonomousSystemNumber | .1.3.6.1.4.1.164.11.4.2.1.7 |
| bgpPeerLastError The last error code and subcode sent or received on this
connection. If no error has occurred, this field is zero.
Otherwise, the first byte of this two byte OCTET STRING
contain… | column | OctetString | .1.3.6.1.4.1.164.11.4.2.1.8 |
| bgpPeerFsmEstablishedTime This timer indicates how long this peer has been in the
Established state or how long since this peer was last in the
Established state. It is set to zero when a new peer is
conf… | column | seconds SNMPv2-SMIGauge32 | .1.3.6.1.4.1.164.11.4.2.1.9 |