dm3ConfigConvFailComm

PowerNet-MIB · .1.3.6.1.4.1.318.1.1.7.2.4.2.1.7
MIB view Table view

Object

scalar mandatory r/w Integer32 
Converter Communication Fail timeout.  This OID represents the time interval in which there is no
communication between the converter and the master controller at which the converter will reset
all its values to default.
          
Values are represented in hundredths of Seconds.
Attempts to set the value above or below the acceptable range of the powerplant
 will cause the value to be set at the high or low point of the range respectively.

Context

MIB
PowerNet-MIB
OID
.1.3.6.1.4.1.318.1.1.7.2.4.2.1.7
Type
scalar
Access
readwrite
Status
mandatory
Parent
dm3ConfigConvThresh
Siblings
6

Syntax

Integer32
Source
COPS-PR-SPPIInteger32
Base type
Integer32

Values & Constraints

Type Constraints
range: -2147483648..2147483647

Related Objects

Sibling Objects
ObjectTypeSyntaxOID
dm3ConfigConvHighVoltThresh mandatory
Converter high voltage threshold. If converter voltage exceeds threshold a converter high voltage alarm will occur. Values are represented in thousandths of Volts (mV)…
scalarInteger32.1.3.6.1.4.1.318.1.1.7.2.4.2.1.1
dm3ConfigConvLowVoltThresh mandatory
Converter low voltage threshold. If converter voltage exceeds threshold a converter low voltage alarm will occur. Values are represented in thousandths of Volts (mV). …
scalarInteger32.1.3.6.1.4.1.318.1.1.7.2.4.2.1.2
dm3ConfigConvFailSafe mandatory
Converter Fail Safe point. This OID represents the value sent to converter controllers to use in the event of communications loss with the Master Controller or Master Controller …
scalarInteger32.1.3.6.1.4.1.318.1.1.7.2.4.2.1.3
dm3ConfigConvSetPoint mandatory
Converter Set point. This OID represents the initial set point used in the voltage control loop. Units are thousandths of Volts (mV). Attempts to set the value above o…
scalarInteger32.1.3.6.1.4.1.318.1.1.7.2.4.2.1.4
dm3ConfigConvFailMax mandatory
Converter Fail Maximum limit. This OID represents the value sent to the converter controllers to define the maximum set point allowed. Units are thousandths of Volts (…
scalarInteger32.1.3.6.1.4.1.318.1.1.7.2.4.2.1.5
dm3ConfigConvFailMin mandatory
Converter Fail Minimum limit. This OID represents the value sent to the converter controllers to define the minimum set point allowed. Units are thousandths of Volts (…
scalarInteger32.1.3.6.1.4.1.318.1.1.7.2.4.2.1.6