airFMSysHumSensBand

PowerNet-MIB · .1.3.6.1.4.1.318.1.1.13.1.4.6.7
MIB view Table view

Object

scalar mandatory r/w Integer32 
The percentage of relative humidity below the
setpoint at which the humidifier will output at 100%
of capacity.  Measured in percent relative humidity.
A value of -2147483648 indicates that this OID does
not apply to this device due to its configuration.

Context

MIB
PowerNet-MIB
OID
.1.3.6.1.4.1.318.1.1.13.1.4.6.7
Type
scalar
Access
readwrite
Status
mandatory
Parent
airFMSysHumidify
Siblings
6

Syntax

Integer32
Source
COPS-PR-SPPIInteger32
Base type
Integer32

Values & Constraints

Type Constraints
range: -2147483648..2147483647

Related Objects

Sibling Objects
ObjectTypeSyntaxOID
airFMSysHumState mandatory
Set the mode to enabled or disabled. Disabled modes will not operate, and you cannot make changes to their settings while they are disabled. A value of notApplicable indicates tha…
scalarEnumeration.1.3.6.1.4.1.318.1.1.13.1.4.6.1
airFMSysHumEssFunction mandatory
Set the priority of the mode for alarms and events with the nonessential stop behavior. Nonessential modes are disabled during nonessential stop alarms and events. A value of notA…
scalarEnumeration.1.3.6.1.4.1.318.1.1.13.1.4.6.2
airFMSysHumSetpoint mandatory
The target value for the selected control sensor air for this mode. It must be at least 1.0 % RH below the dehumidification setpoint. Measured in tenths of percent relative humid…
scalarInteger32.1.3.6.1.4.1.318.1.1.13.1.4.6.3
airFMSysHumDeadband mandatory
The humidity range that controls output when the selected control sensor humidity is below the setpoint. At the top of this range, the humidification mode outputs at 100%. The dea…
scalarInteger32.1.3.6.1.4.1.318.1.1.13.1.4.6.4
airFMSysHumCtrlSetting mandatory
Set the method to control the humidity in the room. The two methods are Relative Humidity (RH) or Dew Point of the selected control sensor air. The dew point method helps correct …
scalarEnumeration.1.3.6.1.4.1.318.1.1.13.1.4.6.5
airFMSysActualHumCtrl mandatory
The humidity control method the system is using. A value of notApplicable indicates that this OID does not apply to this device due to its configuration.
scalarEnumeration.1.3.6.1.4.1.318.1.1.13.1.4.6.6