airFMSysDehumCapacity

PowerNet-MIB · .1.3.6.1.4.1.318.1.1.13.1.4.7.5
MIB view Table view

Object

scalar mandatory r/w Enumeration 
Set the dehumidification mode to use either half of
the cooling coil or the full coil when dehumidifying
the room.
A value of notApplicable indicates that this OID does
not apply to this device due to its configuration.

Context

MIB
PowerNet-MIB
OID
.1.3.6.1.4.1.318.1.1.13.1.4.7.5
Type
scalar
Access
readwrite
Status
mandatory
Parent
airFMSysDehumidify
Siblings
8

Syntax

Enumeration

Values & Constraints

Enumerated Values
1notApplicable
2half
3full

Related Objects

Sibling Objects
ObjectTypeSyntaxOID
airFMSysDehumState mandatory
Set the mode to enabled or disabled. Disabled modes will not operate, and you cannot make changes to their settings while they are disabled. A value of notApplicable indicates tha…
scalarEnumeration.1.3.6.1.4.1.318.1.1.13.1.4.7.1
airFMSysDehumEssFunction mandatory
Set the priority of the mode for alarms and events with the nonessential stop behavior. Nonessential modes are disabled during nonessential stop alarms and events. A value of notA…
scalarEnumeration.1.3.6.1.4.1.318.1.1.13.1.4.7.2
airFMSysDehumSetpoint mandatory
The target value for the selected control sensor air for this mode. It must be at least 1.0 % RH above the humidification setpoint if a humidifier is installed. Measured in tenth…
scalarInteger32.1.3.6.1.4.1.318.1.1.13.1.4.7.3
airFMSysDehumDeadband mandatory
The humidity range above the setpoint at which the dehumidification mode will output at 100%. The deadband does not apply to PID controlled modes. Measured in tenths of percent re…
scalarInteger32.1.3.6.1.4.1.318.1.1.13.1.4.7.4
airFMSysDehumPIDMethod mandatory
Set the multipliers that the PID algorithm will use to calculate the output. Proportional, Proportional + Integral, or Proportional + Integral + Derivative. A value of notApplicab…
scalarEnumeration.1.3.6.1.4.1.318.1.1.13.1.4.7.6
airFMSysDehumPIDGainP mandatory
Set the proportional multiplier to correct for differences between the selected control sensor actual humidity and the setpoint. Measured in %/%RH. A value of -2147483648 indicat…
scalarInteger32.1.3.6.1.4.1.318.1.1.13.1.4.7.7
airFMSysDehumPIDResetRateI mandatory
Set the integral multiplier to correct for the proportional offset. Measured in %/(%RH * min). A value of -2147483648 indicates that this OID does not apply to this device due to…
scalarInteger32.1.3.6.1.4.1.318.1.1.13.1.4.7.8
airFMSysDehumPIDDerivativeD mandatory
Set the derivative multiplier to counteract overshoot and droop during changes in the room humidity. Measure in %/(%RH / min). A value of -2147483648 indicates that this OID does …
scalarInteger32.1.3.6.1.4.1.318.1.1.13.1.4.7.9