newSpectrumMgmtLoopMeasurementMethod – PDN-SPECTRUMMGMT-MIB

Object

column Enumeration

This object indicates the measurement method used in
describing the Loop Length of a circuit. Following are the
details of each of the options:
              
    none(1)       - Indicates that the Spectral Compliance
                    is NOT dependant on any Loop Length
                    measurements or configurations.
    loopLength(2) - The 'ConfLoopLength' object is used to
                    determine spectral compliance. The
                    'ConfEWL' &amp; 'ConfQuadMode' objects are
                    not used in this mode.
    ewl(3)        - The 'ConfEWL' object is used to
                    configure the estimated loop length,
                    which is used to determine spectral
                    compliance. In this mode the
                    'ConfLoopLength' &amp; 'ConfQuadMode'
                    objects are not used.
    quadMode(4)   - The 'ConfQuadMode' object is used to
                    determine spectral compliance. The
                    'ConfEWL' &amp; 'ConfLoopLength' objects
                    are not used in this mode.
              
This object determines which of the three objects :
'ConfEWL', 'ConfLoopLength' or 'ConfQuadMode' is used
(if any) to enforce spectrally compliant maximum
'Tx Rates' and the maximum allowed 'Tx Power' on a given
circuit.

Context

MIB: PDN-SPECTRUMMGMT-MIB
OID: .1.3.6.1.4.1.1795.2.24.2.6.19.2.1.1.3
Type: column
Access: readonly
Status: current
Parent: newSpectrumMgmtGeneralConfigEntry
Table: newSpectrumMgmtGeneralConfigTable
Siblings: 3

Syntax

Enumeration

Values & Constraints

Enumerated Values

`1`	none
`2`	loopLength
`3`	ewl
`4`	quadMode

Related Objects

Sibling Objects

Object	Type	Syntax	OID
newSpectrumMgmtSelection This object is used to Enable or Disable Spectrum Management on DSL interfaces managed by this device. Enabling this object limits the DSL speeds on each port based on line leng…	column	Enumeration	`.1.3.6.1.4.1.1795.2.24.2.6.19.2.1.1.1`
newSpectrumMgmtMode This object restricts the MAX-ACCESS of the 'Selection' object. Following are the details of each of the values: enableOnly(1) - Indicates that the 'Selection'…	column	Enumeration	`.1.3.6.1.4.1.1795.2.24.2.6.19.2.1.1.2`
newSpectrumMgmtEWLUnits This object indicates the units of measurement used in describing the Estimated Working Length of a circuit. Following are the details of each of the units: non…	column	Enumeration	`.1.3.6.1.4.1.1795.2.24.2.6.19.2.1.1.4`