osEthElpRevertDelay

OS-ETH-SERV-PROTECTION-MIB · .1.3.6.1.4.1.6926.2.33.1.1.6
MIB view Table view

Object

column r/w milliseconds Integer32 
Following a recovery from signal failure on the WORKING
trail, time in milliseconds to wait until switching over
to the WORKING trail.
(-1) indicates Do-Not-Revert.
0 indicates revert immediately when recovery is detected

Context

MIB
OS-ETH-SERV-PROTECTION-MIB
OID
.1.3.6.1.4.1.6926.2.33.1.1.6
Type
column
Access
readwrite
Status
current
Units
milliseconds
Parent
osEthServElpEntry
Table
osEthServElpTable
Siblings
19

Syntax

milliseconds Integer32

Values & Constraints

Object Constraints
range: -1-0 range: 10-86400000

Related Objects

Sibling Objects
ObjectTypeSyntaxOID
osEthElpApsMacAddress
The MAC Address that is used as destination in TX APS PDUs and also used to trap RX APS PDUs.
columnSNMPv2-TCMacAddress.1.3.6.1.4.1.6926.2.33.1.1.1
osEthElpTrackCcm
Enable tracking of CCM timeout events. Timeout on the specified MA (and optionally RMEP) assigned to the service will be considered as signal failure.
columnEnumeration.1.3.6.1.4.1.6926.2.33.1.1.2
osEthElpActiveTrail
Current active trail for the service.
columnEnumeration.1.3.6.1.4.1.6926.2.33.1.1.20
osEthElpPendingCommand
The pending managment command within the G.8031 logic. Note that a pending command may be silently cleared by the G.8031 logic once a higher priority condition is encountered.
columnElpCommand.1.3.6.1.4.1.6926.2.33.1.1.21
osEthElpApsRxCount
The total number of APS packets received with valid content.
columnSNMPv2-SMICounter32.1.3.6.1.4.1.6926.2.33.1.1.22
osEthElpApsTxCount
The total number of APS packets transmitted
columnSNMPv2-SMICounter32.1.3.6.1.4.1.6926.2.33.1.1.23
osEthElpFsmStateName
The current state of the G.8031 Final-State-Machine. This value is a string with the name of the state.
columnOctetString.1.3.6.1.4.1.6926.2.33.1.1.24
osEthElpFarEndFsmStateName
The far-end's last reported state of the G.8031 Final-State-Machine. This value is a string with the name of the state.
columnOctetString.1.3.6.1.4.1.6926.2.33.1.1.25
osEthElpTrackCcmStateWorking
The CCM tracking state of the WORKING trail.
columnCcmTrackState.1.3.6.1.4.1.6926.2.33.1.1.26
osEthElpTrackCcmStateProtection
The CCM tracking state of the PROTECTION trail.
columnCcmTrackState.1.3.6.1.4.1.6926.2.33.1.1.27
osEthElpTimeToRevert
Time in seconds until ELP is going to revert from PROTECTION to WORKING.
columnseconds SNMPv2-SMIInteger32.1.3.6.1.4.1.6926.2.33.1.1.28
osEthElpWorkingSignalState
The signal state of the WORKING trail. Based on CCM tracking and port link state.
columnTrailSignalState.1.3.6.1.4.1.6926.2.33.1.1.29
osEthElpRemoteMepIdWorking
Indicates a remote MEP Id that send CCMs. A timeout event for that remote MEP will be considered an ELP signal failure on the WORKING trail
columnOS-COMMON-TC-MIBOsCfmMepIdOrZero.1.3.6.1.4.1.6926.2.33.1.1.3
osEthElpProtectionSignalState
The signal state of the PROTECTION trail. Based on CCM tracking and port link state.
columnTrailSignalState.1.3.6.1.4.1.6926.2.33.1.1.30
osEthElpRemoteMepIdProtection
Indicates a remote MEP Id that send CCMs. A timeout event for that remote MEP will be considered an ELP signal failure on the PROTECTION trail
columnOS-COMMON-TC-MIBOsCfmMepIdOrZero.1.3.6.1.4.1.6926.2.33.1.1.4
osEthElpProtectionIndexName
Service identifier of the row that holds the protection information for the service
columnOctetString.1.3.6.1.4.1.6926.2.33.1.1.40
osEthElpHoldOffDelay
Time in milliseconds to hold-off switch over in case of a failure event.
columnmilliseconds Integer32.1.3.6.1.4.1.6926.2.33.1.1.5
osEthElpCommand
Issue a Command to mainpulate the G.8031 state machine. Note that command may be rejected if a higher priority condition is in effect. This is effectively a write-only field. GET …
columnElpCommand.1.3.6.1.4.1.6926.2.33.1.1.7
osEthElpAdminStatus
Create - create a protection row in osEthServTable in which proteection trail properties such as s-vlan and s-ports should be configured. delete - delete the protection row in osE…
columnEnumeration.1.3.6.1.4.1.6926.2.33.1.1.98