osEthElpHoldOffDelay
OS-ETH-SERV-PROTECTION-MIB ·
.1.3.6.1.4.1.6926.2.33.1.1.5
Object
column
r/w
milliseconds Integer32
Time in milliseconds to hold-off switch over in case of a failure event.
Context
- MIB
- OS-ETH-SERV-PROTECTION-MIB
- OID
.1.3.6.1.4.1.6926.2.33.1.1.5- Type
- column
- Access
- readwrite
- Status
- current
- Units
- milliseconds
- Parent
- osEthServElpEntry
- Table
- osEthServElpTable
- Siblings
- 19
Syntax
milliseconds Integer32
Values & Constraints
Object Constraints
range: 0-0
range: 100-60000
Related Objects
Sibling Objects
| Object | Type | Syntax | OID |
|---|---|---|---|
| osEthElpApsMacAddress The MAC Address that is used as destination in TX APS PDUs
and also used to trap RX APS PDUs. | column | SNMPv2-TCMacAddress | .1.3.6.1.4.1.6926.2.33.1.1.1 |
| osEthElpTrackCcm Enable tracking of CCM timeout events. Timeout on the
specified MA (and optionally RMEP) assigned to the service
will be considered as signal failure. | column | Enumeration | .1.3.6.1.4.1.6926.2.33.1.1.2 |
| osEthElpActiveTrail Current active trail for the service. | column | Enumeration | .1.3.6.1.4.1.6926.2.33.1.1.20 |
| osEthElpPendingCommand The pending managment command within the G.8031 logic.
Note that a pending command may be silently cleared by
the G.8031 logic once a higher priority condition is
encountered. | column | ElpCommand | .1.3.6.1.4.1.6926.2.33.1.1.21 |
| osEthElpApsRxCount The total number of APS packets received with valid
content. | column | SNMPv2-SMICounter32 | .1.3.6.1.4.1.6926.2.33.1.1.22 |
| osEthElpApsTxCount The total number of APS packets transmitted | column | SNMPv2-SMICounter32 | .1.3.6.1.4.1.6926.2.33.1.1.23 |
| osEthElpFsmStateName The current state of the G.8031 Final-State-Machine.
This value is a string with the name of the state. | column | OctetString | .1.3.6.1.4.1.6926.2.33.1.1.24 |
| osEthElpFarEndFsmStateName The far-end's last reported state of the G.8031
Final-State-Machine.
This value is a string with the name of the state. | column | OctetString | .1.3.6.1.4.1.6926.2.33.1.1.25 |
| osEthElpTrackCcmStateWorking The CCM tracking state of the WORKING trail. | column | CcmTrackState | .1.3.6.1.4.1.6926.2.33.1.1.26 |
| osEthElpTrackCcmStateProtection The CCM tracking state of the PROTECTION trail. | column | CcmTrackState | .1.3.6.1.4.1.6926.2.33.1.1.27 |
| osEthElpTimeToRevert Time in seconds until ELP is going to revert from
PROTECTION to WORKING. | column | seconds SNMPv2-SMIInteger32 | .1.3.6.1.4.1.6926.2.33.1.1.28 |
| osEthElpWorkingSignalState The signal state of the WORKING trail.
Based on CCM tracking and port link state. | column | TrailSignalState | .1.3.6.1.4.1.6926.2.33.1.1.29 |
| osEthElpRemoteMepIdWorking Indicates a remote MEP Id that send CCMs. A timeout
event for that remote MEP will be considered an ELP signal
failure on the WORKING trail | column | OS-COMMON-TC-MIBOsCfmMepIdOrZero | .1.3.6.1.4.1.6926.2.33.1.1.3 |
| osEthElpProtectionSignalState The signal state of the PROTECTION trail.
Based on CCM tracking and port link state. | column | TrailSignalState | .1.3.6.1.4.1.6926.2.33.1.1.30 |
| osEthElpRemoteMepIdProtection Indicates a remote MEP Id that send CCMs. A timeout
event for that remote MEP will be considered an ELP signal
failure on the PROTECTION trail | column | OS-COMMON-TC-MIBOsCfmMepIdOrZero | .1.3.6.1.4.1.6926.2.33.1.1.4 |
| osEthElpProtectionIndexName Service identifier of the row that holds the protection
information for the service | column | OctetString | .1.3.6.1.4.1.6926.2.33.1.1.40 |
| osEthElpRevertDelay Following a recovery from signal failure on the WORKING
trail, time in milliseconds to wait until switching over
to the WORKING trail.
(-1) indicates Do-Not-Revert.
0 indicates re… | column | milliseconds Integer32 | .1.3.6.1.4.1.6926.2.33.1.1.6 |
| osEthElpCommand Issue a Command to mainpulate the G.8031 state
machine. Note that command may be rejected if a higher
priority condition is in effect.
This is effectively a write-only field. GET … | column | ElpCommand | .1.3.6.1.4.1.6926.2.33.1.1.7 |
| osEthElpAdminStatus Create - create a protection row in osEthServTable in
which proteection trail properties such as s-vlan and
s-ports should be configured.
delete - delete the protection row in osE… | column | Enumeration | .1.3.6.1.4.1.6926.2.33.1.1.98 |