optIfODUkNimDirectionality
OPT-IF-MIB ·
.1.3.6.1.2.1.10.133.1.8.4.1.1
Object
column
OptIfSinkOrSource
Specifies the monitor point for the ODUk Path non-intrusive
monitoring function. The value source(2) is not allowed
if the corresponding instance of optIfODUkDirectionality
has the value sink(1), and the value sink(1) is not allowed
if the corresponding instance of optIfODUkDirectionality
has the value source(2). Either the value sink(1) or
source(2) is allowed if the corresponding instance of
optIfODUkDirectionality has the value bidirectional(3).
The value sink(1) means monitoring at the sink direction
path signal of the ODUk CTP.
The value source(2) means monitoring at the source direction
path signal of the ODUk CTP. Monitoring the source direction
of an ODUk CTP is necessary in those cases where the ODUk CTP
is at an SNCP (Subnetwork Connection Protection) end (e.g., see
Figure I.1.2/G.874.1). If one would like to get the performance
of the protected connection, one cannot use the NIM function
at both ODUk CTP sinks (before the matrix), instead one should
monitor the signal at the source ODUk CTP after the matrix.
Context
- MIB
- OPT-IF-MIB
- OID
.1.3.6.1.2.1.10.133.1.8.4.1.1- Type
- column
- Access
- noaccess
- Status
- current
- Parent
- optIfODUkNimConfigEntry
- Table
- optIfODUkNimConfigTable
- Siblings
- 9
Syntax
OptIfSinkOrSource
- Source
- OptIfSinkOrSource
- Base type
Enumeration
Values & Constraints
Type Values
1 | sink |
2 | source |
Related Objects
Sibling Objects
| Object | Type | Syntax | OID |
|---|---|---|---|
| optIfODUkNimRowStatus This columnar object is used for creating and deleting
a conceptual row of the optIfODUkNim config table.
It is used to model the activateNim and deactivateNim
operations of an OT… | column | SNMPv2-TCRowStatus | .1.3.6.1.2.1.10.133.1.8.4.1.10 |
| optIfODUkNimDAPIExpected The DAPI expected by the receiver.
This object has no effect if optIfODUkNimTIMDetMode has
the value off(1) or sapi(3). | column | OptIfExDAPI | .1.3.6.1.2.1.10.133.1.8.4.1.2 |
| optIfODUkNimSAPIExpected The SAPI expected by the receiver.
This object has no effect if optIfODUkNimTIMDetMode has
the value off(1) or dapi(2). | column | OptIfExSAPI | .1.3.6.1.2.1.10.133.1.8.4.1.3 |
| optIfODUkNimTraceIdentifierAccepted The actual trace identifier accepted. The value of
this object is unspecified if optIfODUkNimCurrentStatus
has any of the bit positions oci(0), lck(1), or ssf(5)
set or if optIfO… | column | OptIfAcTI | .1.3.6.1.2.1.10.133.1.8.4.1.4 |
| optIfODUkNimTIMDetMode Indicates the mode of the Trace Identifier Mismatch (TIM)
Detection function. | column | OptIfTIMDetMode | .1.3.6.1.2.1.10.133.1.8.4.1.5 |
| optIfODUkNimTIMActEnabled Indicates whether the Trace Identifier Mismatch (TIM)
Consequent Action function is enabled. | column | SNMPv2-TCTruthValue | .1.3.6.1.2.1.10.133.1.8.4.1.6 |
| optIfODUkNimDEGThr Indicates the threshold level for declaring a performance
monitoring (PM) Second to be bad. A PM Second is declared bad
if the percentage of detected errored blocks in that secon… | column | percentage OptIfDEGThr | .1.3.6.1.2.1.10.133.1.8.4.1.7 |
| optIfODUkNimDEGM Indicates the threshold level for declaring a Degraded Signal
defect (dDEG). A dDEG shall be declared if optIfODUkNimDEGM
consecutive bad PM Seconds are detected. | column | OptIfDEGM | .1.3.6.1.2.1.10.133.1.8.4.1.8 |
| optIfODUkNimCurrentStatus Indicates the defect condition of the entity, if
any. The value of this object is unspecified if
optIfODUkNimRowStatus has any value other than
active(1). | column | Bits | .1.3.6.1.2.1.10.133.1.8.4.1.9 |