ostPoePortPseStatus
OMNITRON-POE-MIB ·
.1.3.6.1.4.1.7342.15.2.1.7
Object
column
r/w
Enumeration
This object is the PoE PSE port status.
notApplicable(1) PD device not connected or port disabled
pdNormal(2) PD device is being powered fully
pdOverCurrent(3) PD device is consuming too much current
pdBrownOut(4) PD device is not fully powered
pdInsufficientPower(5) PD device not powered due to lack of power
A write to this object restarts the PSE function and classification.
Context
- MIB
- OMNITRON-POE-MIB
- OID
.1.3.6.1.4.1.7342.15.2.1.7- Type
- column
- Access
- readwrite
- Status
- current
- Parent
- ostPoePortCfgEntry
- Table
- ostPoePortCfgTable
- Siblings
- 15
Syntax
Enumeration
Values & Constraints
Enumerated Values
1 | notApplicable |
2 | pdNormal |
3 | pdOverCurrent |
4 | pdBrownOut |
5 | pdInsufficientPower |
Related Objects
Sibling Objects
| Object | Type | Syntax | OID |
|---|---|---|---|
| ostPoePortCfgIndex An index that is used to identify a specific PoE port number. | column | OMNITRON-TC-MIBOstPortSingleIndex | .1.3.6.1.4.1.7342.15.2.1.1 |
| ostPoePortHeartbeatInterval This object is the PoE PSE PD heartbeat transmission interval in seconds. | column | Unsigned32 | .1.3.6.1.4.1.7342.15.2.1.10 |
| ostPoePortHeartbeatErrorDetection This object is the PoE PSE PD heartbeat number of consecutively lost
heartbeat pings before an errored condition is declared. The number
of consecutive error counts is cleared whe… | column | Unsigned32 | .1.3.6.1.4.1.7342.15.2.1.11 |
| ostPoePortHeartbeatErrorAction This object is the PoE PSE heartbeat errored condition action.
errorLostIgnored(1) PD heartbeat errored condition is ignored
errorRestart(2) PD heartb… | column | Enumeration | .1.3.6.1.4.1.7342.15.2.1.12 |
| ostPoePortHeartbeatNumberRestarts This object is the PoE PSE PD number of restarts when an errored
hearbeat condition occurs. This object is only used when
ostPoePortHeartbeatErrorAction is configured as 'errorRes… | column | Unsigned32 | .1.3.6.1.4.1.7342.15.2.1.13 |
| ostPoEPortHeartbeatStatus This object is the PoE PSE PD heartbeat status.
heartbeatDisabled(1) PSE PD heartbeat is disabled
heartbeatAvailable(2) PSE PD heartbeats are being received
he… | column | Enumeration | .1.3.6.1.4.1.7342.15.2.1.14 |
| ostPoEPortHeartbeatDeferTime This object is the PoE heartbeat PSE PD heartbeat transmission delay
interval in seconds after the port has been reenabled. The delay is
the amount of time after power has been ap… | column | Unsigned32 | .1.3.6.1.4.1.7342.15.2.1.15 |
| ostPoePortHeartbeatIpAddressString This object is the PoE PD heartbeat IPv4 or IPv6 address to ping.
Setting this object also impacts the ostPoePortHeartbeatIpAddress
returned value. If an IPv4 addre… | column | OMNITRON-TC-MIBOstIpAddr | .1.3.6.1.4.1.7342.15.2.1.16 |
| ostPoePortPseEnable This object is the PoE PSE port enable.
pseDisabled(1) PSE power source is disabled
pseEnabled(2) PSE power source is enabled | column | Enumeration | .1.3.6.1.4.1.7342.15.2.1.2 |
| ostPoePortPseMaxMode The object is the PoE maximum mode enable. This is the same control as
the physical DIP switch.
pseMaxNotAvail PSE maximum mode function not available
pse… | column | Enumeration | .1.3.6.1.4.1.7342.15.2.1.3 |
| ostPoePortPdMode This object is the PoE PD classification mode.
pdModeNotDetected(1) PD is not detected
pdModeNotClassified(2) PD is not classified
pdModeFailure(3) PD… | column | Enumeration | .1.3.6.1.4.1.7342.15.2.1.4 |
| ostPoePortPseVoltageSupplied This object indicates the voltage output from the PSE port in volts. | column | OMNITRON-TC-MIBOstFloatValue | .1.3.6.1.4.1.7342.15.2.1.5 |
| ostPoePortPseCurrentSupplied This object indicates the current output from the PSE port in mA
(milliamps). | column | OMNITRON-TC-MIBOstFloatValue | .1.3.6.1.4.1.7342.15.2.1.6 |
| ostPoePortHeartbeatEnable This object is the PoE PSE heartbeat enable.
heartbeatDisabled(1) PSE PD heartbeat is disabled
heartbeatEnabled(2) PSE PD heartbeat is enabled | column | Enumeration | .1.3.6.1.4.1.7342.15.2.1.8 |
| ostPoePortHeartbeatIpAddress This object is the PoE PD heartbeat IPv4 address to ping.
Setting this object also impacts the ostPoePortHeartbeatIpAddressString
returned value. If an IPv4 address… | column | SNMPv2-SMIIpAddress | .1.3.6.1.4.1.7342.15.2.1.9 |