ethIfgAheadInterface

NETI-ETH-MIB · .1.3.6.1.4.1.2928.2.2.1.3.10.1.5
MIB view Table view

Object

column SNMPv2-SMIUnsigned32 
The value of ethIfIndex of the interface that is ahead of
the other.  A value of zero (0) implies invalid, i.e. no
channel is established.  If only one interface is a member
of the interface group, then that interface is considered
ahead.

Context

MIB
NETI-ETH-MIB
OID
.1.3.6.1.4.1.2928.2.2.1.3.10.1.5
Type
column
Access
readonly
Status
current
Parent
ethIfgEntry
Table
ethIfgTable
Siblings
10

Syntax

SNMPv2-SMIUnsigned32
Source
SNMPv2-SMIUnsigned32
Base type
Unsigned32

Values & Constraints

Type Constraints
range: 0..4294967295

Related Objects

Sibling Objects
ObjectTypeSyntaxOID
ethIfgRowStatus
See SNMPv2-TC. The following values are supported: active(1). The object always reads active. createAndGo(4). A new conceptual row is created represe…
columnSNMPv2-TCRowStatus.1.3.6.1.4.1.2928.2.2.1.3.10.1.1
ethIfgActiveInterface
The value of ethIfIndex of the interface from where frames are currently being forwarded. If the ethIfgProtectionStatus is `unavailable(1)' then the value is zero (0).
columnSNMPv2-SMIUnsigned32.1.3.6.1.4.1.2928.2.2.1.3.10.1.10
ethIfgExpectChannel
Controls whether a channel is expected to be terminated on this ETS TTPs for the member interfaces or not. This value can only be set if the mode (ethEtsMode) is multicast. …
columnSNMPv2-TCTruthValue.1.3.6.1.4.1.2928.2.2.1.3.10.1.11
ethIfgMembers
A list of the interfaces that are members of the interface group. An interface is added or removed from an interface group from the interface using ethIfInterfaceGroup.
columnInterfaceIndexList.1.3.6.1.4.1.2928.2.2.1.3.10.1.2
ethIfgDifferentialDelay
The measured difference delay in microseconds between the two channels in the interface group.
columnSNMPv2-SMIUnsigned32.1.3.6.1.4.1.2928.2.2.1.3.10.1.3
ethIfgDifferentialDelayValid
Specifies if the value of ethIfgDifferentialDelay is valid or not.
columnSNMPv2-TCTruthValue.1.3.6.1.4.1.2928.2.2.1.3.10.1.4
ethIfgHitlessProtection
Specifies if hitless protection shall be attempted or not. true(1). Will attempt to reach a hitless protection state. false(2). Will only attempt t…
columnSNMPv2-TCTruthValue.1.3.6.1.4.1.2928.2.2.1.3.10.1.6
ethIfgProtectionStatus
The current protection state.
columnIfgProtectionStatus.1.3.6.1.4.1.2928.2.2.1.3.10.1.7
ethIfgExpectedProtectionStatus
The expected protection state. When the current protection state (see ethIfgProtectionStatus) is lower than the expected protection state, an alarm is raised. The alarm is clear…
columnIfgProtectionStatus.1.3.6.1.4.1.2928.2.2.1.3.10.1.8
ethIfgForceHit
A write of zero (0) resets the buffers, and will therefore minimize the the latency penalty incurred by the 1+1 buffering.
columnSNMPv2-SMIUnsigned32.1.3.6.1.4.1.2928.2.2.1.3.10.1.9