softwareCuRepSwNotDistributed

LUM-SOFTWARE-MIB · .1.3.6.1.4.1.8708.2.28.2.8.7
MIB view Table view

Object

scalar LUM-TCFaultStatus 
Some SW package(s) needed to perform a CU replacement with
automatic upgrade are not transferred to a traffic unit. This
means that CU replacement with auto-upgrade will not work on
this node.
          
Note that this alarm might be seen in up to approximately 5
minutes after a 'SW not downloaded' alarm is cleared to inform
that SW packages are not yet distributed.
          
Possible reasons:
1. If parts of the master CU software were updated without an
  enm-spec file there might be a mismatch between executing
  and expected software resulting in this alarm. If so
  perform a full upgrade to preferred enm-spec version.
2. More than one traffic unit might be needed to distribute
  software, insert another traffic unit into the node main
  subrack or if running CU-SFP as master CU, reconfigure the
  'Supported replacement CUs' attribute to the control unit
  type(s) appropriate for your system.

Context

MIB
LUM-SOFTWARE-MIB
OID
.1.3.6.1.4.1.8708.2.28.2.8.7
Type
scalar
Access
readonly
Status
current
Parent
softwareCuRep
Siblings
7

Syntax

LUM-TCFaultStatus
Source
LUM-TCFaultStatus
Base type
Enumeration

Values & Constraints

Type Values
1ok
2alarm

Related Objects

Sibling Objects
ObjectTypeSyntaxOID
softwareCuRepAdminStatus
The administrative state for the alarm. down - No alarm will be rasied if SW packages are missing. service - No alarm will be rasied if SW packages are missi…
scalarLUM-TCBoardOrInterfaceAdminStatus.1.3.6.1.4.1.8708.2.28.2.8.1
softwareCuRepUnSaved
If the configuration is saved or not.
scalarEnumeration.1.3.6.1.4.1.8708.2.28.2.8.2
softwareCuRepSystemMode
If dipswitch is changed or not.
scalarSNMPv2-SMIUnsigned32.1.3.6.1.4.1.8708.2.28.2.8.3
softwareCuRepRebootCu
If the CU should be rebooted or not.
scalarEnumeration.1.3.6.1.4.1.8708.2.28.2.8.4
softwareCuRepOkConfigure
Configure an CU that has correct SW. Run automatically when in CU replacement mode when CU is an CU-SFP AND SW is correct. Asks for the following: Configuration not sav…
scalarLUM-TCCommandString.1.3.6.1.4.1.8708.2.28.2.8.5
softwareCuRepSwPackagesMissing
Software package file(s) are missing on master CU. When replacing or introducing CU or TU units some software packages needs to be downloaded to the master CU in order …
scalarLUM-TCFaultStatus.1.3.6.1.4.1.8708.2.28.2.8.6
softwareCuRepSupportedReplacements
The types of control unit boards which should be supported as replacements for the current main control unit. The system will transfer the software packages for the boa…
scalarEnumeration.1.3.6.1.4.1.8708.2.28.2.8.8