juniAtmOamF4FlowEndToEndLoopbackTimer
Juniper-UNI-ATM-MIB ·
.1.3.6.1.4.1.4874.2.2.8.1.1.8.1.3
Object
column
r/w
seconds Integer32
Configure the timer for sending the F4 flow end-to-end loopback OAM cells. Setting this value will enable sending the F4 end cells on the circuit. It is not allowed to set the value to -1 and whenever it is read as -1 that means sending end loopback is not enabled. Setting the loopback timer, other than -1, will enable sending the end cells.
Context
- MIB
- Juniper-UNI-ATM-MIB
- OID
.1.3.6.1.4.1.4874.2.2.8.1.1.8.1.3- Type
- column
- Access
- readwrite
- Status
- current
- Units
- seconds
- Parent
- juniAtmOamF4FlowEndToEndCfgEntry
- Table
- juniAtmOamF4FlowEndToEndCfgTable
- Siblings
- 5
Syntax
seconds Integer32
Values & Constraints
Object Constraints
range: -1-600
Related Objects
Sibling Objects
| Object | Type | Syntax | OID |
|---|---|---|---|
| juniAtmOamF4FlowEndToEndIfIndex The ifIndex of the ATM interface to configure the F4 OAM end-to-end
flow. | column | IF-MIBInterfaceIndex | .1.3.6.1.4.1.4874.2.2.8.1.1.8.1.1 |
| juniAtmOamF4FlowEndToEndVpi Select the VPI for F4 OAM end-to-end flow configuration. | column | Integer32 | .1.3.6.1.4.1.4874.2.2.8.1.1.8.1.2 |
| juniAtmOamF4FlowEndToEndCCSink Enable/Disable F4 flow end-to-end continuity check sink end point for
this VP. | column | SNMPv2-TCTruthValue | .1.3.6.1.4.1.4874.2.2.8.1.1.8.1.4 |
| juniAtmOamF4FlowEndToEndCCSource Enable/Disable F4 flow end-to-end continuity check source end point for
this VP. | column | SNMPv2-TCTruthValue | .1.3.6.1.4.1.4874.2.2.8.1.1.8.1.5 |
| juniAtmOamF4FlowEndToEndRowStatus Controls creation/deletion of entries in this table according to the
RowStatus textual convention, constrained to support the following
values only:
createAndGo
destroy
… | column | SNMPv2-TCRowStatus | .1.3.6.1.4.1.4874.2.2.8.1.1.8.1.6 |