juniAtm1483ProfileAutoConfLockoutMin

The lower bound, in seconds, of the time range used to specify 
the duration of the lockout of the encapsulation type from 
recognition for the specified interface.  This only takes effect
if juniAtm1483ProfileAutoConfEnable is set to enable for the
encapsulation type for this interface.
The ability to lockout the specified encapsulation type from
recognition in the event of an error in creating an interface of
the encapsulation type is enabled by default.  The initial lockout
duration is this object's value and increases exponentially for 
each failure that occurs for the specified encapsulation type
for the specified interface within the greater of 15 minutes and
juniAtm1483ProfileAutoConfLockoutMax.  The lockout duration for the
specified encapsulation type will not exceed 
juniAtm1483ProfileAutoConfLockoutMax.  If the time between creation
errors for the specified encapsulation type for the specified
interface is greater than the greater of 15 minutes and
juniAtm1483ProfileAutoConfLockoutMax, then the lockout duration
reverts to this object's value. 
To disable the ability to lockout the specified encapsulation type 
from recognition in the event of an error in creating an interface
of the encapsulation type for the specified interface, the value of
this object and juniAtm1483ProfileAutoConfLockoutMax must be set to 0.
It is not recommended that this lockout feature be disabled except 
for debugging purposes.

MIB

Juniper-ATM-1483-Profile-MIB

OID

.1.3.6.1.4.1.4874.2.2.58.1.1.2.1.4

Type

column

Access

readwrite

Status

current

Parent

juniAtm1483ProfileAutoConfEntry

Table

juniAtm1483ProfileAutoConfTable

Siblings

4