juniAtm1483ProfileAutoConfLockoutMax

The upper bound, in seconds, of the time range used to specify 
the duration of the lockout of the encapsulation type from 
recognition for the specified interface.  This value must equal
or exceed the value for juniAtm1483ProfileAutoConfLockoutMin.  This
only takes effect if juniAtm1483ProfileAutoConfEnable is set to 
enable for the encapsulation type for this interface.
The ability to lockout the specified encapsulation type from
recognition in the event of an error in creating an interface of
the encapsulation type is enabled by default.  The initial lockout
duration is juniAtm1483ProfileAutoConfLockoutMin and increases
exponentially for each failure that occurs for the specified
encapsulation type for the specified interface within the greater 
of 15 minutes and this object's value.  The lockout duration for
the specified encapsulation type will not exceed this object's
value.  If the time between creation errors for the specified
encapsulation type for the specified interface is greater than
the greater of 15 minutes and this object's value, then the
lockout duration reverts to juniAtm1483ProfileAutoConfLockoutMin. 
To disable the ability to lockout the specified encapsulation type 
from recognition in the event of an error in creating an interface
of the encapsulation type for the specified interface, the value of
this object and juniAtm1483ProfileAutoConfLockoutMin must be set to 0.
It is not recommended that this lockout feature be disabled except 
for debugging purposes.

MIB

Juniper-ATM-1483-Profile-MIB

OID

.1.3.6.1.4.1.4874.2.2.58.1.1.2.1.5

Type

column

Access

readwrite

Status

current

Parent

juniAtm1483ProfileAutoConfEntry

Table

juniAtm1483ProfileAutoConfTable

Siblings

4