hpICMPRateLimitPortPrct
HP-ICF-RATE-LIMIT-MIB ·
.1.3.6.1.4.1.11.2.14.10.2.14.1.1.1.1.1.3
Object
column
r/w
Integer32
This indicates the percent of ICMP rate limit on the port. The value of this object must be interpreted under the context of hpICMPRateLimitPortState. A value of 0 is not the same as disabling, but rather all ICMP traffic must be dropped.
Context
- MIB
- HP-ICF-RATE-LIMIT-MIB
- OID
.1.3.6.1.4.1.11.2.14.10.2.14.1.1.1.1.1.3- Type
- column
- Access
- readwrite
- Status
- current
- Parent
- hpICMPRateLimitPortConfigEntry
- Table
- hpICMPRateLimitPortConfigTable
- Siblings
- 6
Syntax
Integer32
Values & Constraints
Object Constraints
range: 0-100
Related Objects
Sibling Objects
| Object | Type | Syntax | OID |
|---|---|---|---|
| hpICMPRateLimitPortConfigIndex The interface index associated with this entry. | column | IF-MIBInterfaceIndex | .1.3.6.1.4.1.11.2.14.10.2.14.1.1.1.1.1.1 |
| hpICMPRateLimitPortState deprecated This object indicates whether ICMP rate limiting is
enabled on the corresponding port.
Because this is a State object it cannot distinguish
between percent-based IC… | column | Enumeration | .1.3.6.1.4.1.11.2.14.10.2.14.1.1.1.1.1.2 |
| hpICMPRateLimitPortAlarmFlag This object indicates whether ICMP rate limiting
alarm has been sent. When an alarm is sent, this
object is set to set(2). Once a management station
changes this object to clea… | column | Enumeration | .1.3.6.1.4.1.11.2.14.10.2.14.1.1.1.1.1.4 |
| hpICMPRateLimitPortKbps The maximum Kilobits-per-second of ICMP traffic that may
be received inbound on the port. The value of this
object must be interpreted under the context of
hpICMPRateLimitCont… | column | SNMPv2-SMIInteger32 | .1.3.6.1.4.1.11.2.14.10.2.14.1.1.1.1.1.5 |
| hpICMPRateLimitPortControlMode The mode by which inbound ICMP traffic on this port will
Rate-Limited. If icmpRateLimitPerPortOnly is configured,
there will be a single maximum percentage-based rate for
the … | column | Enumeration | .1.3.6.1.4.1.11.2.14.10.2.14.1.1.1.1.1.6 |
| hpICMPRateLimitPortIpPacketType This object represents the type(s) of IP packet to which
the specified ICMP rate-limit will be applied. The
default is IPv4. | column | Enumeration | .1.3.6.1.4.1.11.2.14.10.2.14.1.1.1.1.1.7 |