hpICMPRateLimitPortIpPacketType

Object

column r/w Enumeration

This object represents the type(s) of IP packet to which
the specified ICMP rate-limit will be applied. The
default is IPv4.

Sibling Objects

Object	Type	Syntax	OID
hpICMPRateLimitPortConfigIndex The interface index associated with this entry.	column	IF-MIBInterfaceIndex	`.1.3.6.1.4.1.11.2.14.10.2.14.1.1.1.1.1.1`
hpICMPRateLimitPortState deprecated This object indicates whether ICMP rate limiting is enabled on the corresponding port. Because this is a State object it cannot distinguish between percent-based IC…	column	Enumeration	`.1.3.6.1.4.1.11.2.14.10.2.14.1.1.1.1.1.2`
hpICMPRateLimitPortPrct This indicates the percent of ICMP rate limit on the port. The value of this object must be interpreted under the context of hpICMPRateLimitPortState. A value of 0 is not the…	column	Integer32	`.1.3.6.1.4.1.11.2.14.10.2.14.1.1.1.1.1.3`
hpICMPRateLimitPortAlarmFlag This object indicates whether ICMP rate limiting alarm has been sent. When an alarm is sent, this object is set to set(2). Once a management station changes this object to clea…	column	Enumeration	`.1.3.6.1.4.1.11.2.14.10.2.14.1.1.1.1.1.4`
hpICMPRateLimitPortKbps The maximum Kilobits-per-second of ICMP traffic that may be received inbound on the port. The value of this object must be interpreted under the context of hpICMPRateLimitCont…	column	SNMPv2-SMIInteger32	`.1.3.6.1.4.1.11.2.14.10.2.14.1.1.1.1.1.5`
hpICMPRateLimitPortControlMode The mode by which inbound ICMP traffic on this port will Rate-Limited. If icmpRateLimitPerPortOnly is configured, there will be a single maximum percentage-based rate for the …	column	Enumeration	`.1.3.6.1.4.1.11.2.14.10.2.14.1.1.1.1.1.6`